Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM1000000026S7X
Model Year Start: 2023 Model: RAV4 Prod Date Range: [10/2022 -           ]
Title: CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B157011,B157013; Indicator (Red) Circuit Short to Ground; 2023 - 2024 MY RAV4 RAV4 HV [10/2022 -        ]

DTC

B157011

Indicator (Red) Circuit Short to Ground

DTC

B157013

Indicator (Red) Circuit Open

DESCRIPTION

This DTC is stored when the DCM (telematics transceiver) detects an open or short in the manual (SOS) switch red indicator circuit of the manual (SOS) switch.

The manual (SOS) switch red indicator illuminates for 2 seconds and goes off when the ignition switch is turned to ON. If a malfunction in the safety connect system is detected, the manual (SOS) switch red indicator will illuminate.

However, the manual (SOS) switch red indicator may not illuminate when this DTC is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

DTC Output from

Priority

B157011

Indicator (Red) Circuit Short to Ground

Manual (SOS) switch red indicator impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON

  • DCM (telematics transceiver)
  • Map light sub-assembly (manual [SOS] switch)
  • Harness or connector

Telematics

A

B157013

Indicator (Red) Circuit Open

Manual (SOS) switch red indicator impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON

  • DCM (telematics transceiver)
  • Map light sub-assembly (manual [SOS] switch)
  • Harness or connector

Telematics

A

WIRING DIAGRAM

for 9 Speakers:
for 6 Speakers:

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

Click here 2023 - 2024 MY RAV4 RAV4 HV [10/2022 -        ]; CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: PRECAUTION

HINT:

If DTC B157011 or B157013 is stored, the manual (SOS) switch red indicator may not illuminate when another DTC is stored.

PROCEDURE

1.

CLEAR DTC

Pre-procedure1

(a) Turn the ignition switch to ON and wait for 10 seconds or more.

Procedure1

(b) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

Post-procedure1

(c) None

NEXT

2.

CHECK FOR DTC

(a) Check for DTCs.

Body Electrical > Telematics > Trouble Codes

Result

Proceed to

DTCs are not output

A

DTCs are output (for 9 Speakers)

B

DTCs are output (for 6 Speakers)

C

A

USE SIMULATION METHOD TO CHECK

C

GO TO STEP 6

B

3.

INSPECT MAP LIGHT SUB-ASSEMBLY (MANUAL [SOS] SWITCH) (RED INDICATOR)

Pre-procedure1

(a) Remove the map light sub-assembly (manual [SOS] switch).

HINT:

Click here 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; LIGHTING (INT): PERSONAL LIGHT: REMOVAL

*A

for TMC Made

*B

for TMMC Made

*a

Component without harness connected

(Map Light Sub-assembly (Manual [SOS] Switch))

(b) Connect 2 dry-cell batteries (1.5 V each) in series.

(c) for TMC Made:

Connect a positive (+) lead from the batteries to terminal 10 (IND1) and a negative (-) lead to terminal 14 (GND3) of the map light sub-assembly (manual [SOS] switch) connector.

for TMMC Made:

Connect a positive (+) lead from the batteries to terminal 11 (IND1) and a negative (-) lead to terminal 10 (GND3) of the map light sub-assembly (manual [SOS] switch) connector.

Procedure1

(d) Check if the illumination for the manual (SOS) switch red indicator comes on.

OK:

Red indicator comes on.

Post-procedure1

(e) None

NG

REPLACE MAP LIGHT ASSEMBLY (MANUAL [SOS] SWITCH)

OK

4.

CHECK HARNESS AND CONNECTOR (DCM [TELEMATICS TRANSCEIVER] - MAP LIGHT SUB-ASSEMBLY)

Pre-procedure1

(a) Disconnect the G131 DCM (telematics transceiver) connector.

(b) Disconnect the P20*1 or P14*2 map light sub-assembly (manual [SOS] switch) connector.

  • *1: for TMC Made
  • *2: for TMMC Made

Procedure1

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

for TMC Made

Tester Connection

Condition

Specified Condition

G131-4 (IND1) - P20-10 (IND1)

Always

Below 1 Ω

G131-4 (IND1) or P20-10 (IND1) - Body ground

Always

10 kΩ or higher

G131-3 (SIG-) - P20-14 (GND3)

Always

Below 1 Ω

G131-3 (SIG-) or P20-14 (GND3) - Body ground

Always

10 kΩ or higher

for TMMC Made

Tester Connection

Condition

Specified Condition

G131-4 (IND1) - P14-11 (IND1)

Always

Below 1 Ω

G131-4 (IND1) or P14-11 (IND1) - Body ground

Always

10 kΩ or higher

G131-3 (SIG-) - P14-10 (GND3)

Always

Below 1 Ω

G131-3 (SIG-) or P14-10 (GND3) - Body ground

Always

10 kΩ or higher

Post-procedure1

(d) None

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

5.

REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver).

HINT:

Click here 2023 - 2024 MY RAV4 RAV4 HV [10/2022 -        ]; CELLULAR COMMUNICATION: DCM(TELEMATICS TRANSCEIVER): REMOVAL

NOTICE:

  • The ignition switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION

6.

INSPECT MAP LIGHT SUB-ASSEMBLY (MANUAL [SOS] SWITCH) (RED INDICATOR)

Pre-procedure1

(a) Remove the map light sub-assembly (manual [SOS] switch).

HINT:

Click here 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; LIGHTING (INT): PERSONAL LIGHT: REMOVAL

*A

for TMC Made or for TMMC Made, with Panoramic Moon Roof System

*B

for TMMC Made, without Panoramic Moon Roof System

*a

Component without harness connected

(Map Light Sub-assembly (Manual [SOS] Switch))

(b) Connect 2 dry-cell batteries (1.5 V each) in series.

(c) for TMC Made or for TMMC Made, with Panoramic Moon Roof System:

Connect a positive (+) lead from the batteries to terminal 10 (IND1) and a negative (-) lead to terminal 14 (SIG-) of the map light sub-assembly (manual [SOS] switch) connector.

for TMMC Made, without Panoramic Moon Roof System:

Connect a positive (+) lead from the batteries to terminal 11 (IND1) and a negative (-) lead to terminal 10 (GND3) of the map light sub-assembly (manual [SOS] switch) connector.

Procedure1

(d) Check if the illumination for the manual (SOS) switch red indicator comes on.

OK:

Red indicator comes on.

Post-procedure1

(e) None

NG

REPLACE MAP LIGHT ASSEMBLY (MANUAL [SOS] SWITCH)

OK

7.

CHECK HARNESS AND CONNECTOR (DCM [TELEMATICS TRANSCEIVER] - MAP LIGHT SUB-ASSEMBLY)

Pre-procedure1

(a) Disconnect the G131 DCM (telematics transceiver) connector.

(b) Disconnect the P20*1 or P14*2 map light sub-assembly (manual [SOS] switch) connector.

  • *1: for TMC Made or for TMMC Made, with Panoramic Moon Roof System
  • *2: for TMMC Made, without Panoramic Moon Roof System

Procedure1

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

for TMC Made or for TMMC Made, with Panoramic Moon Roof System

Tester Connection

Condition

Specified Condition

G131-4 (IND1) - P20-10 (IND1)

Always

Below 1 Ω

G131-4 (IND1) or P20-10 (IND1) - Body ground

Always

10 kΩ or higher

G131-3 (SIG-) - P20-14 (SIG-)

Always

Below 1 Ω

G131-3 (SIG-) or P20-14 (SIG-) - Body ground

Always

10 kΩ or higher

for TMMC Made, without Panoramic Moon Roof System

Tester Connection

Condition

Specified Condition

G131-4 (IND1) - P14-11 (IND1)

Always

Below 1 Ω

G131-4 (IND1) or P14-11 (IND1) - Body ground

Always

10 kΩ or higher

G131-3 (SIG-) - P14-10 (GND3)

Always

Below 1 Ω

G131-3 (SIG-) or P14-10 (GND3) - Body ground

Always

10 kΩ or higher

Post-procedure1

(d) None

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

8.

REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver).

HINT:

Click here 2023 - 2024 MY RAV4 RAV4 HV [10/2022 -        ]; CELLULAR COMMUNICATION: DCM(TELEMATICS TRANSCEIVER): REMOVAL

NOTICE:

  • The ignition switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION