| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM1000000026O6R |
| Model Year Start: 2023 | Model: RAV4 | Prod Date Range: [10/2022 - ] |
| Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Odo/Trip Switch Malfunction; 2023 - 2024 MY RAV4 RAV4 HV [10/2022 - ] | ||
|
Odo/Trip Switch Malfunction |
DESCRIPTION
The ODO/TRIP display of the combination meter changes each time the trip switch is pressed.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
PROCEDURE
|
1. |
READ VALUE USING GTS (ODO/TRIP CHANGE SWITCH) |
(a) Using the GTS, read the Data List.
Body Electrical > Combination Meter > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
ODO/TRIP Change Switch |
ODO/TRIP switch (Trip switch) |
OFF or ON |
OFF: ODO/TRIP switch (trip switch) released ON: ODO/TRIP switch (trip switch) pushed |
- |
Body Electrical > Combination Meter > Data List
|
Tester Display |
|---|
|
ODO/TRIP Change Switch |
OK:
ODO/TRIP switch condition displayed on the GTS changes with the actual switch operation.
| OK |
|
|
|
2. |
INSPECT TRIP SWITCH |
(a) Remove the trip switch.
Click here
![2023 - 2024 MY RAV4 RAV4 HV [10/2022 - ]; METER / GAUGE / DISPLAY: TRIP SWITCH: REMOVAL](/t3Portal/stylegraphics/info.gif)
(b) Inspect the trip switch.
Click here
| NG |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TRIP SWITCH) |
(a) Disconnect the G140 combination meter assembly connector.
(b) Disconnect the G142 trip switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G140-13 (ODO) - G142-5 (A/B) |
Always |
Below 1 Ω |
|
G140-26 (SW3) - G142-2 (E) |
Always |
Below 1 Ω |
|
G140-13 (ODO) or G142-5 (A/B) - Body ground |
Always |
10 kΩ or higher |
|
G140-26 (SW3) or G142-2 (E) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|