Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM1000000021GUK |
Model Year Start: 2022 |
Model: RAV4 HV |
Prod Date Range: [12/2021 -
] |
Title: EXTERIOR PANELS / TRIM: GRILLE SHUTTER SYSTEM (for HV Model): Grille Shutter does not Operate; 2022 - 2024 MY RAV4 HV [12/2021 - ] |
Grille Shutter does not Operate
|
DESCRIPTION
The radiator shutter assembly may not operate due to foreign matter, such as snow or dirt, or a drop in voltage.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Before performing troubleshooting, change the grille shutter control mode to maintenance mode.
Click here
-
If the radiator shutter assembly has been replaced with a new one, perform initialization and change the grille shutter control mode.
Click here
-
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
1.
|
CHECK FOR FOREIGN OBJECT
|
(a) Check that the radiator shutter assembly is free of foreign matter and ice.
OK:
The radiator shutter assembly is free of foreign matter and ice.
NG |
|
FOREIGN OBJECT (REMOVE FOREIGN MATTER AND/OR ICE)
|
OK
|
|
|
2.
|
CHECK RADIATOR SHUTTER ASSEMBLY
|
(a) Remove the radiator shutter assembly.
Click here
(b) Manually open and close the radiator shutter assembly and check that it moves smoothly.
OK:
The radiator shutter assembly moves smoothly.
OK
|
|
|
(a) Clear the DTCs.
Powertrain > Engine > Clear DTCs
(b) Turn the power switch off and wait for at least 30 seconds.
NEXT
|
|
|
(a) Check for DTCs.
Powertrain > Engine > Trouble Codes
OK:
DTCs are not output.
OK
|
|
|
5.
|
CHECK RADIATOR SHUTTER ASSEMBLY
|
(a) Disconnect the A108 radiator shutter assembly connector.
(b) Turn the power switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
A108-1 (+B) - A108-3 (GND)
|
Power switch ON
|
11 to 14 V
|
OK |
|
END (TEMPORARILY NOT OPERABLE DUE TO FAIL-SAFE (TEMPERATURE ABNORMALITY))
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|