Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM1000000021GUE
Model Year Start: 2022 Model: RAV4 Prod Date Range: [12/2021 - 10/2022]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Parking Brake Switch Circuit; 2022 MY RAV4 RAV4 HV [12/2021 - 10/2022]

Parking Brake Switch Circuit

DESCRIPTION

This circuit is from the skid control ECU (brake actuator assembly) to the radio and display receiver assembly.*1

This circuit is from the No. 2 skid control ECU (brake actuator assembly) to the radio and display receiver assembly.*2

  • *1: for Gasoline Model
  • *2: for HV Model

WIRING DIAGRAM

PROCEDURE

1.

CHECK BRAKE WARNING LIGHT

(a) Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.

Result

Proceed to

OK (for Gasoline Model)

A

OK (for HV Model)

B

NG

C

B

GO TO STEP 3

C

GO TO ELECTRIC PARKING BRAKE SYSTEM

for Gasoline Model: Click here 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM (w/ Vacuum Brake Booster): HOW TO PROCEED WITH TROUBLESHOOTING

for HV Model: Click here 2022 - 2024 MY RAV4 RAV4 HV [12/2021 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster): HOW TO PROCEED WITH TROUBLESHOOTING

A

2.

CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) - RADIO AND DISPLAY RECEIVER ASSEMBLY)

(a) Disconnect the G2 radio and display receiver assembly connector.

(b) Disconnect the A39 skid control ECU (brake actuator assembly) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G2-20 (PKB) - A39-35 (PKB)

Always

Below 1 Ω

G2-20 (PKB) or A39-35 (PKB) - Body ground

Always

10 kΩ or higher

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.

CHECK HARNESS AND CONNECTOR (NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) - RADIO AND DISPLAY RECEIVER ASSEMBLY)

(a) Disconnect the G2 radio and display receiver assembly connector.

(b) Disconnect the A105 No. 2 skid control ECU (brake actuator assembly) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G2-20 (PKB) - A105-24 (PKB)

Always

Below 1 Ω

G2-20 (PKB) or M36-5 (PKB) - Body ground

Always

10 kΩ or higher

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR