Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM10000000201YI
Model Year Start: 2022 Model: RAV4 Prod Date Range: [12/2021 -           ]
Title: LIGHTING (INT): PERSONAL LIGHT: INSPECTION; 2022 - 2024 MY RAV4 RAV4 HV [12/2021 -        ]

INSPECTION

PROCEDURE

1. INSPECT MAP LIGHT ASSEMBLY

(a) Inspect the map light.

Apply auxiliary battery voltage to the connector and check the light illumination condition.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

12 (+B1) - Auxiliary battery positive (+)

13 (GND) - Auxiliary battery negative (-)

Map light switch LH ON

Map light LH illuminates

Map light switch RH ON

Map light RH illuminates

Dome light switch ON

Map light LH and RH illuminates

If the result is not as specified, replace the map light assembly.

*a

Component without harness connected

(Map Light Assembly)

(b) Inspect the door switch.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 (CTY) - 4 (RLMP)

Door switch OFF

10 kΩ or higher

Door switch ON

Below 1 Ω

If the result is not as specified, replace the map light assembly.

(c) Inspect the switch illumination.

Apply auxiliary battery voltage to the connector and check the light illumination condition.

OK:

Measurement Condition

Condition

Specified Condition

21 (ILLB) - Auxiliary battery positive (+)

15 (LILL) - Auxiliary battery negative (-)

Always

Illuminates

If the result is not as specified, replace the map light assembly.