| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM10000000201LL |
| Model Year Start: 2022 | Model: RAV4 | Prod Date Range: [12/2021 - ] |
| Title: LIGHTING (EXT): HEADLIGHT ASSEMBLY(for Single Beam Headlight): REMOVAL; 2022 - 2024 MY RAV4 RAV4 HV [12/2021 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight assembly LH removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
|
Replaced Part or Performed Procedures |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Front bumper assembly (Including removal and installation) |
Front television camera view adjustment |
Panoramic view monitor system (for Gasoline model) |
|
Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
|
Replaced Part or Performed Procedures |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Front bumper assembly (Including removal and installation) |
Front television camera view adjustment |
Panoramic view monitor system (for HV model) |
|
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
-
except Off Road Package:
Click here
![2022 - 2024 MY RAV4 RAV4 HV [12/2021 - ]; EXTERIOR PANELS / TRIM: FRONT BUMPER (except Off Road Package): REMOVAL](/t3Portal/stylegraphics/info.gif)
-
for Off Road Package:
Click here
2. REMOVE HEADLIGHT ASSEMBLY LH
(a) Apply protective tape as shown in the illustration.
|
Screw |
|
Bolt |
|
Protective Tape |
(b) Remove the 3 screws and bolt.
(c) Place your hand on 2 brackets of the headlight assembly LH to disconnect them from the screw seats.
|
*a |
Lower Bracket |
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
NOTICE:
Be careful not to break the bracket.
(d) Slide the headlight assembly LH in the direction indicated by the arrow (1) and detach the guide and lower bracket.
(e) Slide the headlight assembly LH in the direction indicated by the arrow (2) to remove it.
|
(f) for LED Type Turn Signal light: (1) Detach the wire harness clamp and disconnect the connector. |
|
|
(g) for Bulb Type Turn Signal Light: (1) Detach the wire harness clamp and disconnect the 4 connectors. |
|
|
|