DESCRIPTIONThis circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly. If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly. If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs. Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself will not function. WIRING DIAGRAMCAUTION / NOTICE / HINTNOTICE: The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System. PROCEDURE
(a) Remove the steering pad switch assembly. (b) Inspect the steering pad switch assembly.
(a) Remove the spiral cable sub-assembly. (b) Inspect the spiral cable sub-assembly.
(a) Disconnect the G3 radio and display receiver assembly connector. (b) Disconnect the G20 spiral with sensor cable sub-assembly connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|