Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001R5I8 |
Model Year Start: 2021 |
Model: RAV4 |
Prod Date Range: [08/2020 - 10/2022] |
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for Gasoline Model): C1625; Open or Short in Steering Angle Sensor +B; 2021 - 2022 MY RAV4 [08/2020 - 10/2022] |
DTC
|
C1625
|
Open or Short in Steering Angle Sensor +B
|
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
C1625
|
Open or Short in Steering Angle Sensor +B
|
Open or short in steering angle sensor +B
|
-
Harness or connector
-
Steering sensor
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Since the panoramic view monitor system has functions that use the CAN communication system, first confirm that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following procedure.
Click here
-
When "!" mark is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
-
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
-
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click here
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (STEERING SENSOR - BATTERY AND BODY GROUND)
|
(a) Disconnect the steering sensor connector.
|
|
*a
|
Front view of wire harness connector
(to Steering Sensor)
|
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G68-6 (ESS) - Body ground
|
Always
|
Below 1 Ω
|
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
w/ Stop and Start System
Tester Connection
|
Condition
|
Specified Condition
|
G68-9 (IG1) - G68-6 (ESS)
|
Engine switch on (IG)
|
10.5 to 16 V
|
G68-4 (BAT) - G68-6 (ESS)
|
Always
|
11 to 14 V
|
w/o Stop and Start System
Tester Connection
|
Condition
|
Specified Condition
|
G68-9 (IG1) - G68-6 (ESS)
|
Engine switch on (IG)
|
11 to 14 V
|
G68-4 (BAT) - G68-6 (ESS)
|
Always
|
11 to 14 V
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|