| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001OR13 |
| Model Year Start: 2020 | Model: RAV4 HV | Prod Date Range: [06/2020 - ] |
| Title: HYBRID / BATTERY CONTROL: MOTOR GENERATOR CONTROL SYSTEM (for LITHIUM-ION BATTERY): P1BFB9E; Battery Discharge Control Circuit Stuck On; 2020 - 2024 MY RAV4 HV [06/2020 - ] | ||
|
DTC |
P1BFB9E |
Battery Discharge Control Circuit Stuck On |
DESCRIPTION
The motor generator ECU located in the inverter with converter assembly receives power from the IGCT power source line and discharge control power source line. A semiconductor switch is installed in the motor generator ECU to switch which is used to switch the discharge control power source line power source on and off.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
Warning Indicate |
|---|---|---|---|---|---|
|
P1BFB9E |
Battery Discharge Control Circuit Stuck On |
When the motor generator ECU is started, the discharge control BAT switch command flag is OFF for a certain period of time, but the discharge control BAT voltage is at or above the threshold at that time. (1 trip detection logic) |
Inverter with converter assembly |
Does not Come on |
Master Warning: Comes on |
CONFIRMATION DRIVING PATTERN
HINT:
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click here
![2020 - 2024 MY RAV4 HV [06/2020 - ]; HYBRID / BATTERY CONTROL: MOTOR GENERATOR CONTROL SYSTEM (for LITHIUM-ION BATTERY): UTILITY](/t3Portal/stylegraphics/info.gif)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the ignition switch off and wait for 2 minutes or more.
- Turn the ignition switch to ON and turn the Techstream on.
- With the ignition switch ON and wait for 10 seconds or more.
- Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
-
Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE, perform driving pattern again.
WIRING DIAGRAM
Refer to a wiring diagram for DTC P1BFCA2.
Click here
PROCEDURE
|
1. |
REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS |
Click here
| NEXT |
|
COMPLETED |
|
|