HYBRID / BATTERY CONTROL: HYBRID BATTERY SYSTEM (for LITHIUM-ION BATTERY): U029387; Lost Communication with Hybrid/EV Powertrain Control Module Missing Message; 2020 - 2024 MY RAV4 HV [06/2020

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001OBER
Model Year Start: 2020	Model: RAV4 HV	Prod Date Range: [06/2020 - ]
Title: HYBRID / BATTERY CONTROL: HYBRID BATTERY SYSTEM (for LITHIUM-ION BATTERY): U029387; Lost Communication with Hybrid/EV Powertrain Control Module Missing Message; 2020 - 2024 MY RAV4 HV [06/2020 - ]

DTC

U029387

Lost Communication with Hybrid/EV Powertrain Control Module Missing Message

DESCRIPTION

The battery ECU assembly transmits and receives signals via CAN communication to and from the hybrid vehicle control ECU assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Warning Indicate

U029387

Lost Communication with Hybrid/EV Powertrain Control Module Missing Message

A CAN communication error between the battery ECU assembly and hybrid vehicle control ECU assembly (CAN communication system malfunction) occurs

(1 trip detection logic)

CAN communication system

Comes on

Master Warning:

Comes on

MONITOR DESCRIPTION

If the battery ECU assembly cannot communicate with the hybrid vehicle control ECU assembly via CAN communication, it will illuminate the MIL and store a DTC.

MONITOR STRATEGY

Related DTCs	U0293 (INF U029387): Lost communication with Hybrid control module
Required sensors/components	Battery ECU assembly
Frequency of operation	Continuous
Duration	TMC's intellectual property
MIL operation	Immediately
Sequence of operation	None

TYPICAL ENABLING CONDITIONS

The monitor will run whenever the following DTCs are not stored	TMC's intellectual property
Other conditions belong to TMC's intellectual property	-

TYPICAL MALFUNCTION THRESHOLDS

TMC's intellectual property

COMPONENT OPERATING RANGE

Battery ECU assembly

DTC U0293 (INF U029387) is not detected

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click here
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
Click here

Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and turn the Techstream on.
With ignition switch ON and wait for 2 minutes or more.[*1]
HINT:

[*1]: Normal judgment procedure.

The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
Enter the following menus: Powertrain / HV Battery / Utility / All Readiness.
Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.

PROCEDURE

1.	CHECK DTC OUTPUT (HV BATTERY)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Check for DTCs.

Powertrain > HV Battery > Trouble Codes

(e) Turn the ignition switch off.

GO TO CAN COMMUNICATION SYSTEM