| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001MH83 |
| Model Year Start: 2020 | Model: RAV4 | Prod Date Range: [01/2020 - 10/2022] |
| Title: CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15C511,B15C513; Emergency Call Switch Circuit Short to Ground; 2020 - 2022 MY RAV4 RAV4 HV [01/2020 - 10/2022] | ||
|
DTC |
B15C511 |
Emergency Call Switch Circuit Short to Ground |
|
DTC |
B15C513 |
Emergency Call Switch Circuit Open |
DESCRIPTION
This DTC is set when the DCM (telephone transceiver assembly) detects an open or short circuit in the manual (SOS) switch.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B15C511 |
Emergency Call Switch Circuit Short to Ground |
Manual (SOS) switch impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON |
|
|
B15C513 |
Emergency Call Switch Circuit Open |
Manual (SOS) switch impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click here TELEMATICS > TELEMATICS SYSTEM > PRECAUTION
PROCEDURE
|
1. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and wait for 10 seconds or more.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Click here
![2020 - 2022 MY RAV4 RAV4 HV [10/2019 - 10/2022]; CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: DTC CHECK / CLEAR](/t3Portal/stylegraphics/info.gif)
Body Electrical > Telematics > Clear DTCs
(f) Check for DTCs and check that no DTCs are output.
Click here
Body Electrical > Telematics > Trouble Codes
OK:
No DTCs are output.
| OK |
|
|
|
2. |
INSPECT MAP LIGHT SUB-ASSEMBLY (MANUAL [SOS] SWITCH) |
|
(a) Remove the map light sub-assembly (manual [SOS] switch). Click here
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for TMC Made
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
22 (SIG1) - 14 (GND3) |
Manual (SOS) switch not operated |
410 to 414 Ω |
|
22 (SIG1) - 14 (GND3) |
Manual (SOS) switch operated |
81 to 83 Ω |
for TMMC Made and w/o Panoramic Moon Roof System
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
9 (SIG1) - 10 (GND3) |
Manual (SOS) switch not operated |
410 to 414 Ω |
|
9 (SIG1) - 10 (GND3) |
Manual (SOS) switch operated |
81 to 83 Ω |
for TMMC Made and w/ Panoramic Moon Roof System
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
18 (SIG1) - 12 (GND3) |
Manual (SOS) switch not operated |
410 to 414 Ω |
|
18 (SIG1) - 12 (GND3) |
Manual (SOS) switch operated |
81 to 83 Ω |
| NG |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (DCM [TELEPHONE TRANSCEIVER ASSEMBLY] - MAP LIGHT SUB-ASSEMBLY (MANUAL [SOS] SWITCH)) |
(a) Disconnect the G131 DCM (telephone transceiver assembly) connector.
(b) Disconnect the P20*1 or P14*2 map light sub-assembly (manual [SOS] switch) connector.
- *1: for TMC Made
- *2: for TMMC Made
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for TMC Made
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G131-21 (SIG1) - P20-22 (SIG1) |
Always |
Below 1 Ω |
|
G131-3 (SIG-) - P20-14 (GND3) |
Always |
Below 1 Ω |
|
G131-21 (SIG1) or P20-22 (SIG1) - Body ground |
Always |
10 kΩ or higher |
|
G131-3 (SIG-) or P20-14 (GND3) - Body ground |
Always |
10 kΩ or higher |
for TMMC Made and w/o Panoramic Moon Roof System
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G131-21 (SIG1) - P14-9 (SIG1) |
Always |
Below 1 Ω |
|
G131-3 (SIG-) - P14-10 (GND3) |
Always |
Below 1 Ω |
|
G131-21 (SIG1) or P14-9 (SIG1) - Body ground |
Always |
10 kΩ or higher |
|
G131-3 (SIG-) or P14-10 (GND3) - Body ground |
Always |
10 kΩ or higher |
for TMMC Made and w/ Panoramic Moon Roof System
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G131-21 (SIG1) - P14-18 (SIG1) |
Always |
Below 1 Ω |
|
G131-3 (SIG-) - P14-12 (GND3) |
Always |
Below 1 Ω |
|
G131-21 (SIG1) or P14-18 (SIG1) - Body ground |
Always |
10 kΩ or higher |
|
G131-3 (SIG-) or P14-12 (GND3) - Body ground |
Always |
10 kΩ or higher |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
4. |
REPLACE DCM (TELEPHONE TRANSCEIVER ASSEMBLY) |
(a) Replace the DCM (telephone transceiver assembly) with a new one.
Click here
NOTICE:
- The ignition switch must be off.
- Do not exchange the DCM (telephone transceiver assembly) with one from another vehicle.
| NEXT |
|
|
|