| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001LRDQ |
| Model Year Start: 2020 | Model: RAV4 HV | Prod Date Range: [10/2019 - 08/2020] |
| Title: P710 (HYBRID TRANSMISSION / TRANSAXLE): SHIFT PADDLE SWITCH: REMOVAL; 2020 MY RAV4 HV [10/2019 - 08/2020] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here |
|||
|
Auxiliary battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane control system |
|
|
Parking support brake system (for HV model)* |
|||
|
Pre-collision system |
|||
|
Lighting system (EXT)(w/ AFS) |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
|
Panoramic view monitor system (for HV model) |
|
||
|
Reset back door close position |
Power back door system (for HV model) |
|
|
|
Back door lock initialization |
Power door lock control system |
|
|
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Auxiliary Battery Terminal
|
System Name |
See Procedure |
|---|---|
|
Vehicle enrolled in Toyota Audio Multimedia system or safety connect system |
6 minutes |
|
Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system |
1 minute |
PROCEDURE
1. REMOVE STEERING WHEEL ASSEMBLY
Click here
![2020 MY RAV4 RAV4 HV [10/2019 - 08/2020]; STEERING COLUMN: STEERING WHEEL: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE STEERING PAD SWITCH ASSEMBLY
Click here
3. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
|
(a) Remove the 2 screws. |
|
|
(b) Disengage the 4 claws. |
|
|
(c) Disengage the 2 clamps to disconnect the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly from the steering wheel assembly. |
|
|
(d) Disconnect the No. 1 transmission shift switch assembly connector and No. 2 transmission shift switch assembly connector to remove the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly from the No. 1 switch wire. |
|
4. REMOVE NO. 1 SWITCH WIRE
HINT:
Perform this procedure only when replacement of the No. 1 switch wire is necessary.
|
(a) Disengage the 2 guides and remove the No. 1 switch wire from the steering wheel assembly. |
|
|
|