|
Last Modified: 05-08-2025 |
6.11:8.1.0 |
Doc ID: RM100000001G234 |
|
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 -
] |
|
Title: THEFT DETERRENT / KEYLESS ENTRY: IMMOBILISER SYSTEM (for Gasoline Model without Smart Key System): B2780; Push Switch / Key Unlock Warning Switch Malfunction; 2019 - 2025 MY RAV4 [11/2018 - ] |
|
DTC
|
B2780
|
Push Switch / Key Unlock Warning Switch Malfunction
|
DESCRIPTION
This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON.
|
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
Note
|
|
B2780
|
Push Switch / Key Unlock Warning Switch Malfunction
|
The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*).
|
-
Wire harness or connector
-
Unlock warning switch assembly
-
Transponder key ECU assembly
|
DTC Output Confirmation Operation:
-
Insert the door control transmitter assembly into the ignition key cylinder.
|
-
*: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected
|
Vehicle Condition when Malfunction Detected
|
Fail-safe Operation when Malfunction Detected
|
|
Engine cannot be started
|
-
|
Related Data List and Active Test
|
DTC No.
|
Data List and Active Test
|
|
B2780
|
Key SW
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Before replacing the transponder key ECU assembly, refer to the Registration.
Click here
-
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
|
1.
|
INSPECT UNLOCK WARNING SWITCH ASSEMBLY
|
(a) Remove the unlock warning switch assembly.
Click here
(b) Inspect the unlock warning switch assembly.
Click here
|
OK
|
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - TRANSPONDER KEY ECU ASSEMBLY AND BODY GROUND)
|
(a) Disconnect the G52 transponder key ECU assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection
|
Condition
|
Specified Condition
|
|
G29-1 - G52-5 (KSW)
|
Always
|
Below 1 Ω
|
|
G29-2 - Body ground
|
Always
|
Below 1 Ω
|
|
G29-1 or G52-5 (KSW) - Other terminals and body ground
|
Always
|
10 kΩ or higher
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|