Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001FXT5 |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 - 10/2023] |
Title: PARK ASSIST / MONITORING: INTUITIVE PARKING ASSIST SYSTEM (for Gasoline Model with Parking Support Brake System): C1AE987; Ultrasonic Sensor (Rear Right Corner) Missing Message; 2019 - 2023 MY RAV4 [11/2018 - 10/2023] |
DTC
|
C1AE987
|
Ultrasonic Sensor (Rear Right Corner) Missing Message
|
DESCRIPTION
This DTC is output when an open circuit or short occurs in the communication line between a rear corner ultrasonic sensor (RR sensor) and the rear center ultrasonic sensor (RRC sensor), or when a malfunction occurs in a rear corner ultrasonic sensor (RR sensor) on the rear.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
C1AE987
|
Ultrasonic Sensor (Rear Right Corner) Missing Message
|
Rear corner ultrasonic sensor (RR sensor) lost communication
|
-
Rear corner ultrasonic sensor (RR sensor)
-
Harness or connector
-
Clearance warning ECU assembly
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
Click here
-
If a DTC is detected again after the repair, turn the engine switch on (IG) and turn the intuitive parking assist system on, and then clear the DTC.
Click here
-
If C1AE896 is output at the same time, check C1AE896 first.
Click here
PROCEDURE
1.
|
VEHICLE CONDITION AND WORK DETAILS CHECK
|
(a) Check the vehicle condition and work details.
Result
|
Proceed to
|
The clearance warning ECU assembly or ultrasonic sensor has not been replaced
|
A
|
The clearance warning ECU assembly or ultrasonic sensor has been replaced
|
B
|
A
|
|
|
2.
|
CHECK CONNECTOR CONNECTION CONDITION (ULTRASONIC SENSOR)
|
(a) Check that the connector is properly connected to the rear corner ultrasonic sensor and rear center ultrasonic sensor.
NEXT
|
|
|
(a) Clear the DTCs.
Body Electrical > Clearance Warning > Clear DTCs
NEXT
|
|
|
(a) Check for DTCs.
Body Electrical > Clearance Warning > Trouble Codes
Result
|
Proceed to
|
C1AE987 is not output
|
A
|
C1AE987 is output
|
B
|
A |
|
END (CONNECTOR CONNECTION MALFUNCTION)
|
B
|
|
|
5.
|
CHECK CONNECTOR CONNECTION CONDITION (CLEARANCE WARNING ECU ASSEMBLY)
|
(a) Check that the connector is properly connected to the clearance warning ECU assembly.
NEXT
|
|
|
(a) Clear the DTCs.
Body Electrical > Clearance Warning > Clear DTCs
NEXT
|
|
|
(a) Recheck for DTCs.
Click here
Body Electrical > Clearance Warning > Trouble Codes
DTC OUTPUT COMBINATION:
Symptoms
|
DTC Detection
|
C1AE687
|
C1AE787
|
C1AE887
|
C1AE987
|
Symptom 1
|
Not output
|
Not output
|
Not output
|
Not output
|
Symptom 2
|
Not output
|
Not output
|
Not output
|
Output
|
Symptom 3
|
Not output
|
Not output
|
Output
|
Output
|
Symptom 4
|
Not output
|
Output
|
Output
|
Output
|
Symptom 5
|
Output
|
Output
|
Output
|
Output
|
Result
|
Proceed to
|
Listed under symptom 1 in combination table
|
A
|
Listed under symptom 2 in combination table
|
B
|
Listed under symptom 3 in combination table
|
C
|
Listed under symptom 4 in combination table
|
D
|
Listed under symptom 5 in combination table
|
E
|
B
|
|
|
8.
|
CHECK HARNESS AND CONNECTOR (REAR CENTER ULTRASONIC SENSOR [RRC SENSOR] - REAR CORNER ULTRASONIC SENSOR [RR SENSOR])
|
(a) Disconnect the Q4 rear center ultrasonic sensor (RRC sensor) connector.
(b) Disconnect the Q3 rear corner ultrasonic sensor (RR sensor) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
Q4-1 (BO) - Q3-4 (BI)
|
Always
|
Below 1 Ω
|
Q4-2 (SO) - Q3-5 (SI)
|
Always
|
Below 1 Ω
|
Q4-3 (EO) - Q3-6 (EI)
|
Always
|
Below 1 Ω
|
Q4-1 (BO) or Q3-4 (BI) - Body ground
|
Always
|
10 kΩ or higher
|
Q4-2 (SO) or Q3-5 (SI) - Body ground
|
Always
|
10 kΩ or higher
|
Q4-3 (EO) or Q3-6 (EI) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
9.
|
REPLACE REAR CORNER ULTRASONIC SENSOR (RR SENSOR)
|
(a) Replace the rear corner ultrasonic sensor (RR sensor) with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
|
|
|
(a) Check for DTCs.
Click here
Body Electrical > Clearance Warning > Trouble Codes
(b) Clear the DTCs.
Click here
Body Electrical > Clearance Warning > Clear DTCs
(c) Recheck for DTCs.
Click here
Body Electrical > Clearance Warning > Trouble Codes
Result
|
Proceed to
|
DTC C1AE987 is not output
|
A
|
DTC C1AE987 is output
|
B
|
A |
|
END (REAR CORNER ULTRASONIC SENSOR [RR SENSOR] WAS DEFECTIVE)
|
|