| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FWRP |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: LIGHTING (INT): LIGHTING SYSTEM: Push Start Switch Illumination Circuit; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] | ||
|
Push Start Switch Illumination Circuit |
DESCRIPTION
The illuminated entry system controls the push start switch illumination.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Check that the "Engine Start Indicator" customization setting is set to "ON".
Click here
![2019 - 2022 MY RAV4 RAV4 HV [11/2018 - 10/2022]; LIGHTING (INT): LIGHTING SYSTEM: CUSTOMIZE PARAMETERS](/t3Portal/stylegraphics/info.gif)
- Before replacing the certification ECU (smart key ECU assembly), refer to Registration.
PROCEDURE
|
1. |
PERFORM ACTIVE TEST USING TECHSTREAM |
(a) Perform the Active Test according to the display on the Techstream.
Click here
Body Electrical > Smart Key > Active Test
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Power/Engine SW Light |
Push start switch illumination |
OFF or ON |
- |
Body Electrical > Smart Key > Active Test
|
Tester Display |
|---|
|
Power/Engine SW Light |
OK:
Push start switch illumination comes on.
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
|
|
2. |
INSPECT PUSH START SWITCH |
(a) Remove the push start switch.
-
for A25A-FKS:
Click here
-
for A25A-FXS:
Click here
(b) Inspect the push start switch.
-
for A25A-FKS:
Click here
-
for A25A-FXS:
Click here
|
Result |
Proceed to |
|---|---|
|
OK |
A |
|
NG (for A25A-FKS) |
B |
|
NG (for A25A-FXS) |
C |
| B |
|
| C |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (PUSH START SWITCH - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY]) |
(a) Disconnect the G55 push start switch connector.
(b) Disconnect the G54 certification ECU (smart key ECU assembly) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G55-9 (SWIL) - G54-10 (SWIL) |
Always |
Below 1 Ω |
|
G55-6 (AGND) - G54-11 (AGND) |
Always |
Below 1 Ω |
|
G55-9 (SWIL) or G54-10 (SWIL) - Body ground |
Always |
10 kΩ or higher |
|
G55-6 (AGND) or G54-11 (AGND) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|