| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FW82 |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: THEFT DETERRENT / KEYLESS ENTRY: THEFT DETERRENT SYSTEM: Unlock Warning Switch Circuit; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] | ||
|
Unlock Warning Switch Circuit |
DESCRIPTION
The key unlock warning switch assembly comes on when the ignition key is inserted into the ignition key cylinder and goes off when the ignition key is removed.
WIRING DIAGRAM
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (KEY UNLOCK WARNING SW) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) According to the display on the Techstream, read the Data List.
Body Electrical > Main Body > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Key Unlock Warning SW |
Un-lock warning switch |
ON or OFF |
ON: Key inserted into ignition key cylinder OFF: Key removed from ignition key cylinder |
- |
Body Electrical > Main Body > Data List
|
Tester Display |
|---|
|
Key Unlock Warning SW |
OK:
When the key is in the ignition key cylinder, "ON" appears on the screen.
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
|
|
2. |
INSPECT UN-LOCK WARNING SWITCH ASSEMBLY |
(a) Remove the un-lock warning switch assembly.
Click here
![2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ]; DOOR LOCK: UNLOCK WARNING SWITCH: REMOVAL](/t3Portal/stylegraphics/info.gif)
(b) Inspect the un-lock warning switch assembly.
Click here
| NG |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (UN-LOCK WARNING SWITCH ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND BODY GROUND) |
(a) Disconnect the 4A instrument panel junction block assembly connector.
(b) Disconnect the G29 un-lock warning switch assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
4A-41 - G29-1 (UN+) |
Always |
Below 1 Ω |
|
4A-41 or G29-1 (UN+) - Other terminals and body ground |
Always |
10 kΩ or higher |
|
G29-2 (UN-) - Body ground |
Always |
Below 1 Ω |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
4. |
INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
(a) Remove the instrument panel junction block assembly.
Click here
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
4A-41 - A-3 (KSW) |
Always |
Below 1 Ω |
| OK |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
|
| NG |
|
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
|
|
|