| Last Modified: 05-08-2025 | 6.11:8.1.0 | Doc ID: RM100000001FQR1 |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 08/2020] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM (w/o Occupant Classification System): OPERATION CHECK; 2019 - 2020 MY RAV4 RAV4 HV [11/2018 - 08/2020] | ||
OPERATION CHECK
PRECAUTION FOR OPERATION CHECK
CAUTION:
Use the correct procedure to replace the airbag parts.
CHECK SRS WARNING LIGHT
(a) Primary check
(1) Turn the ignition switch to ON and check that the SRS warning light turns on.
(2) Turn the ignition switch off. Wait for at least 2 seconds, and then turn the ignition switch to ON. The SRS warning light comes on for approximately 6 seconds and diagnosis of the airbag system (including the seat belt pretensioners) is performed.
NOTICE:
Turn the ignition switch off when the auxiliary battery is connected.
HINT:
- If the warning light remains on for approximately 6 seconds or more after the ignition switch has been turned to ON, there may be a malfunction with the SRS airbag system.
- If the warning light occasionally turns on approximately 6 seconds or more after the ignition switch has been turned to ON, there may be a short to +B, short to ground or an open in the SRS warning light circuit.
- If the warning light illuminates after turning the ignition switch off or ACC, there may be a malfunction in the power source circuit or combination meter assembly.
- The SRS warning light turns off, and then turns on. This blinking pattern indicates a source voltage drop. The SRS warning light turns off 10 seconds after the source voltage returns to normal.
CHECK HORN BUTTON ASSEMBLY
Click here
![2019 - 2020 MY RAV4 RAV4 HV [11/2018 - 08/2020]; SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: ON-VEHICLE INSPECTION](/t3Portal/stylegraphics/info.gif)
CHECK INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY
Click here
CHECK LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
CHECK FRONT SEAT AIRBAG ASSEMBLY
for Manual Seat:
Click here
for Power Seat:
Click here
CHECK CURTAIN SHIELD AIRBAG ASSEMBLY
Click here
CHECK FRONT SEAT OUTER BELT ASSEMBLY
Click here
CHECK AIRBAG ECU ASSEMBLY
Click here
CHECK FRONT AIRBAG SENSOR
Click here
CHECK FLOOR SIDE AIRBAG SENSOR
Click here
CHECK NO. 2 SIDE AIRBAG SENSOR ASSEMBLY
Click here
CHECK SIDE AIRBAG PRESSURE SENSOR
Click here
CHECK HARNESS AND CONNECTOR
(a) for Vehicle not Involved in Collision
(1) Perform a diagnostic system check.
(b) for Vehicle Involved in Collision and Airbag not Deployed
(1) Perform a diagnostic system check.
(c) for Vehicle Involved in Collision and Airbag is Deployed
(1) Perform a diagnostic system check.
(2) Check any of the wire harnesses in exposed contact with the airbag wire harness for damage.
(3) Check the connector of the airbag wire harness for scratches, cracks or damage.
|
|