| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FQP4 |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 10/2023] |
| Title: DOOR / HATCH: POWER BACK DOOR SYSTEM (for Gasoline Model): B2250; Back Door Closer Operation Malfunction; 2019 - 2023 MY RAV4 [11/2018 - 10/2023] | ||
|
DTC |
B2250 |
Back Door Closer Operation Malfunction |
DESCRIPTION
The multiplex network door ECU receives signals from the latch switch, initial switch, pawl switch and back door courtesy switch, which are built into the back door lock with courtesy light switch assembly. Based on these switch signals, the latch position of the back door lock with courtesy light switch assembly is determined.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B2250 |
Back Door Closer Operation Malfunction |
While the back door closer is operating, a malfunction is detected in position information from the initial switch within a specified amount of time. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Click here
![2019 - 2023 MY RAV4 [11/2018 - 10/2023]; DOOR / HATCH: POWER BACK DOOR SYSTEM (for Gasoline Model): INITIALIZATION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM |
(a) Read the Data List according to the display on the Techstream.
Click here
Body Electrical > Back Door > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Closer Position SW |
Initial switch signal |
ON or OFF |
ON: Back door lock sector gear in center position (Initial switch on) OFF: Back door lock sector gear out of center position (Initial switch off) |
- |
Body Electrical > Back Door > Data List
|
Tester Display |
|---|
|
Closer Position SW |
OK:
The display is as specified in the normal condition column.
| OK |
|
|
|
2. |
INSPECT BACK DOOR LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY |
(a) Remove the back door lock with courtesy light switch assembly.
Click here
(b) Inspect the back door lock with courtesy light switch assembly.
Click here
| NG |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY - MULTIPLEX NETWORK DOOR ECU AND BODY GROUND) |
(a) Disconnect the R14 back door lock with courtesy light switch assembly connector.
(b) Disconnect the R18 multiplex network door ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
R14-6 (OPN) - R18-7 (POS) |
Always |
Below 1 Ω |
|
R14-1 (E) - Body ground |
Always |
Below 1 Ω |
|
R14-6 (OPN) or R18-7 (POS) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|