| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FQOY |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 10/2023] |
| Title: DOOR / HATCH: POWER BACK DOOR SYSTEM (for Gasoline Model): B2205; Kick Sensor Circuit; 2019 - 2023 MY RAV4 [11/2018 - 10/2023] | ||
|
DTC |
B2205 |
Kick Sensor Circuit |
DESCRIPTION
B2205 is output when the multiplex network door ECU detects that the kick door control sensor is stuck on.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B2205 |
Kick Sensor Circuit |
One of the following conditions is met for approximately 60 seconds or more:
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
- Before troubleshooting, make sure that the kick door control sensor is not damaged.
-
Before troubleshooting, be sure to read Precautions for Hands Free Power Back Door.
Click here
![2019 - 2023 MY RAV4 [11/2018 - 10/2023]; DOOR / HATCH: POWER BACK DOOR SYSTEM (for Gasoline Model): PRECAUTION](/t3Portal/stylegraphics/info.gif)
-
If the multiplex network door ECU has been removed and installed or replaced, or if any of the connectors has been disconnected, initialize the power back door system.
Click here
-
After performing work, using the Techstream, read the Data List item "Kick Sensor Connection" and check that the kick door control sensor is connected.
Click here
-
Check the smart key system (for Entry Function, Gasoline Model) first before troubleshooting the power back door system.
Click here
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Clear the DTCs.
Click here
Body Electrical > Back Door > Clear DTCs
(b) Wait for approximately 60 seconds.
(c) Check for DTCs.
Click here
Body Electrical > Back Door > Trouble Codes
OK:
DTC B2205 is not output.
| OK |
|
|
|
2. |
CHECK FOR DTC |
(a) Disconnect the Q7 kick door control sensor connector.
(b) Clear the DTCs.
Click here
Body Electrical > Back Door > Clear DTCs
(c) Wait for approximately 60 seconds.
(d) Check for DTCs.
Click here
Body Electrical > Back Door > Trouble Codes
OK:
DTC B2205 is not output.
| OK |
|
REPLACE KICK DOOR CONTROL SENSOR
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - KICK DOOR CONTROL SENSOR) |
(a) Disconnect the R18 multiplex network door ECU connector.
(b) Disconnect the Q7 kick door control sensor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
R18-14 (KSIN) or Q7-3 (KSOT) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|