Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000001FNI6
Model Year Start: 2019 Model: RAV4 Prod Date Range: [11/2018 -           ]
Title: NETWORKING: LIN COMMUNICATION SYSTEM: DATA LIST / ACTIVE TEST; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]

DATA LIST / ACTIVE TEST

DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body or Smart Key / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Main Body > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Communication D-Door Motor

Connection status between front power window regulator motor assembly LH and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication P-Door Motor

Connection status between front power window regulator motor assembly RH and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication RR-Door Motor

Connection status between rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication RL-Door Motor

Connection status between rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication Slide Roof

Connection status between main body ECU (multiplex network body ECU) and sliding roof ECU (sliding roof drive gear sub-assembly)

OK or STOP

OK: Connected

STOP: Not Connected
  • w/ Sliding Roof System, Panoramic Moon Roof System
  • DTC is output if an error occurs in LIN communication.

Communication Master SW

Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU)*

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

The Number of DTC

Number of DTCs

0 to 255

Number of stored DTCs

-
  • *: Although the item is displayed on the Techstream, it is not applicable to this vehicle.

Body Electrical > Smart Key > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

# Codes

Number of DTCs

0 to 255

Number of stored DTCs

-