UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE): COMBINATION SWITCH: INSPECTION; 2019 - 2024 MY RAV4 [11/2018

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001FNF0
Model Year Start: 2019	Model: RAV4	Prod Date Range: [11/2018 - ]
Title: UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE): COMBINATION SWITCH: INSPECTION; 2019 - 2024 MY RAV4 [11/2018 - ]

INSPECTION

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (COMBINATION SWITCH)

(a) Inspect the NORMAL mode switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
8 (B) - 13 (GND)	NORMAL mode switch being pushed and held	Below 1 Ω
8 (B) - 13 (GND)	NORMAL mode switch not pushed	10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a	Component without harness connected (Integration Control and Panel Assembly (Combination Switch))

(b) Inspect the SPORT mode switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
9 (P) - 13 (GND)	SPORT mode switch being pushed and held	Below 1 Ω
9 (P) - 13 (GND)	SPORT mode switch not pushed	10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a	Component without harness connected (Integration Control and Panel Assembly (Combination Switch))

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
7 (ECU) - 13 (GND)	ECO mode switch being pushed and held	Below 1 Ω
7 (ECU) - 13 (GND)	ECO mode switch not pushed	10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a	Component without harness connected (Integration Control and Panel Assembly (Combination Switch))

(d) Inspect the SNOW mode switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
6 (2ND) - 13 (GND)	SNOW mode switch being pushed and held	Below 1 Ω
6 (2ND) - 13 (GND)	SNOW mode switch not pushed	10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a	Component without harness connected (Integration Control and Panel Assembly (Combination Switch))

(e) Inspect the illumination:

(1) Apply battery voltage to the combination switch and check that the switch illuminates.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 12 (ILL+)

Battery negative (-) → Terminal 1 (ILL-)

Illuminates

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a	Component without harness connected (Integration Control and Panel Assembly (Combination Switch))