Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000001FMS8
Model Year Start: 2019 Model: RAV4 Prod Date Range: [11/2018 - 08/2020]
Title: A25A-FKS (ENGINE CONTROL): SFI SYSTEM (w/o Canister Pump Module): Pattern Select Switch Snow Mode Circuit; 2019 - 2020 MY RAV4 [11/2018 - 08/2020]

Pattern Select Switch Snow Mode Circuit

DESCRIPTION

When SNOW mode is selected, the operation of the throttle motor is moderated to control engine output. This helps to reduce skidding of the drive wheels, and assists with takeoff acceleration, driving straightness and turning stability.

WIRING DIAGRAM

PROCEDURE

1.

READ VALUE USING TECHSTREAM (SNOW MODE SW)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine / Data List / Snow Mode SW.

Powertrain > Engine > Data List

Tester Display

Snow Mode SW

(e) Read the value displayed on the Techstream.

OK:

Condition

Techstream Display (Snow Mode SW)

SNOW mode switch pushed and held

ON

SNOW mode switch not pushed

OFF

OK

CHECK FOR INTERMITTENT PROBLEMS

NG

2.

INSPECT COMBINATION SWITCH ASSEMBLY (SNOW MODE SWITCH)

(a) Inspect the combination switch assembly (SNOW mode switch).

Click here 2019 - 2024 MY RAV4 [11/2018 -        ]; UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE): COMBINATION SWITCH: INSPECTION

NG

REPLACE COMBINATION SWITCH ASSEMBLY

OK

3.

CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - ECM)

(a) Disconnect the combination switch assembly connector.

(b) Disconnect the ECM connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G32-6 (2ND) - A24-11 (SNWI)

Always

Below 1 Ω

G32-6 (2ND) or A24-11 (SNWI) - Body ground and other terminals

Always

10 kΩ or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

4.

CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - BODY GROUND)

(a) Disconnect the combination switch assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G32-13 (GND) - Body ground

Always

Below 1 Ω

OK

REPLACE ECM

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR