TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING VALVE: REMOVAL; 2019 MY RAV4 RAV4 HV [11/2018

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001FK8F
Model Year Start: 2019	Model: RAV4	Prod Date Range: [11/2018 - 10/2019]
Title: TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING VALVE: REMOVAL; 2019 MY RAV4 RAV4 HV [11/2018 - 10/2019]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the Tire pressure warning valve and transmitter removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model:)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Tire pressure warning valve and transmitter

Register transmitter ID
Initialize tire pressure warning system

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.
Tire pressure warning function

for Initialization:

for Registration:

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model:)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Tire pressure warning valve and transmitter

Register transmitter ID
Initialize tire pressure warning system

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.
Tire pressure warning function

for Initialization:

for Registration:

PROCEDURE

1. REMOVE FRONT WHEEL

Click here

2. REMOVE REAR WHEEL

Click here

3. REMOVE FULL SIZE SPARE TIRE (w/ Full Size Spare Tire)

4. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

(a) Remove the tire valve cap and valve core to release the air from the tire.

NOTICE:

Keep the removed tire valve cap.

(b) After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Then drop the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the rim.

(c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.

NOTICE:

Be careful as the tire pressure warning valve and transmitter may become damaged due to interference between the sensor and tire bead.
Set the tire remover shoe as shown in the illustration.
Width (A):

10 to 20 mm (0.394 to 0.787 in.)

*1	Tire
*2	Shoe

(d) Separate the upper bead.

(e) Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.

(f) Remove the grommet from the tire pressure warning valve and transmitter.