Last Modified: 05-08-2025 6.11:8.1.0 Doc ID: RM100000001FHAB
Model Year Start: 2019 Model: RAV4 HV Prod Date Range: [11/2018 -           ]
Title: HYBRID / BATTERY CONTROL: COMBINATION SWITCH: INSPECTION; 2019 - 2025 MY RAV4 HV [11/2018 -        ]

INSPECTION

PROCEDURE

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY

(a) Inspect EV mode switch (Integration Control and Panel Assembly)

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G32-6 (S) - G32-13 (GND)

EV mode switch (integration control and panel assembly) being pushed and held

Below 1 Ω

EV mode switch (integration control and panel assembly) not pushed

10 kΩ or higher

If the result is not as specified, replace the EV mode switch (integration control and panel assembly).

*a

Component without harness connected

(EV Mode Switch (Integration Control and Panel Assembly))

(b) Inspect NORMAL mode switch (Integration Control and Panel Assembly)

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G32-8 (B) - G32-13 (GND)

NORMAL mode switch (integration control and panel assembly) being pushed and held

Below 1 Ω

NORMAL mode switch (integration control and panel assembly) not pushed

10 kΩ or higher

If the result is not as specified, replace the NORMAL mode switch (integration control and panel assembly).

*a

Component without harness connected

(NORMAL Mode Switch (Integration Control and Panel Assembly))

(c) Inspect SPORT mode switch (Integration Control and Panel Assembly)

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G32-9 (P) - G32-13 (GND)

SPORT mode switch (integration control and panel assembly) being pushed and held

Below 1 Ω

SPORT mode switch (integration control and panel assembly) not pushed

10 kΩ or higher

If the result is not as specified, replace the SPORT mode switch (integration control and panel assembly).

*a

Component without harness connected

(SPORT Mode Switch (Integration Control and Panel Assembly))

(d) Inspect the illumination:

(1) Apply battery voltage to the integration control and panel assembly and check that the switch illuminates.

OK:

Condition

Specified Condition

Battery positive (+) → G32-12 (ILL+)

Battery negative (-) →G32-1 (ILL-)

Illuminates

If the result is not as specified, replace the combination switch.

*a

Component without harness connected

(Integration Control and Panel Assembly)