P710 (HYBRID TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: ADJUSTMENT; 2019 - 2024 MY RAV4 HV [11/2018

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001FF00
Model Year Start: 2019	Model: RAV4 HV	Prod Date Range: [11/2018 - ]
Title: P710 (HYBRID TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: ADJUSTMENT; 2019 - 2024 MY RAV4 HV [11/2018 - ]

ADJUSTMENT

PROCEDURE

1. SECURE VEHICLE

(a) Fully apply the parking brake and chock a wheel.

CAUTION:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

2. REMOVE CONSOLE BOX ASSEMBLY

Click here

3. REMOVE NO. 1 CONSOLE BOX DUCT

Click here

4. ADJUST SHIFT LEVER POSITION

NOTICE:

Before adjusting the transmission control cable assembly, check that the shift lever position sensor and shift lever are in N.

(a) Disconnect the transmission control cable assembly from the transmission floor shift assembly.

(b) Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.

*a	Slider
*b	Lock Piece
*c	Slide
*d	Pull

NOTICE:

Check that the lock piece is pulled out.
Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.
Connect the transmission control cable assembly so that the lock piece faces the driver side.

*a	Lock Piece
*b	Adjuster Case

(d) Push the lock piece into the adjuster case.

NOTICE:

Check that the shift lever position sensor and shift lever are in N.
Securely push in the lock piece until the slider lock is engaged.
Make sure that lever shaft position is not moved in shift direction during adjuster locking operation.
- Do not touch lever shaft and knob during locking operation.
- Do not pull or push adjuster case in shift direction during locking operation.

*a	Lock Piece
*b	Push In
*c	Adjuster Case

(e) After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again.

5. INSTALL NO. 1 CONSOLE BOX DUCT

Click here

6. INSTALL CONSOLE BOX ASSEMBLY

Click here