Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001FAJL |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 - 10/2022] |
Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1694; Steering Angle Initialization Incomplete; 2019 - 2022 MY RAV4 RAV4 HV [11/2018 - 10/2022] |
DTC
|
C1694
|
Steering Angle Initialization Incomplete
|
DESCRIPTION
This DTC is stored when the television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
C1694
|
Steering Angle Initialization Incomplete
|
Maximum steering angle has not been memorized (steering angle setting is incomplete)
|
-
Steering angle setting
-
Television camera assembly
|
CAUTION / NOTICE / HINT
NOTICE:
-
If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".
Click here
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click here
PROCEDURE
(a) Perform the following procedure depending on the memory conditions to register the vehicle information into the television camera assembly.
(1) Steering angle setting.
Click here
NEXT
|
|
|
(a) Clear the DTCs.
Click here
Chassis > Rear Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Click here
Chassis > Rear Camera > Trouble Codes
HINT:
-
If DTC C1694 is output, perform the steering angle setting again.
-
If DTC C1694 is still output after performing the steering angle setting 3 times, replace the television camera assembly.
Result
|
Proceed to
|
DTC C1694 is not output
|
A
|
DTC C1694 is output
|
B
|
A |
|
END
|
|