| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001EV9D |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 08/2020] |
| Title: A25A-FKS (ENGINE CONTROL): ACTIVE CONTROL ENGINE MOUNT (for Rear Side): ON-VEHICLE INSPECTION; 2019 - 2020 MY RAV4 [11/2018 - 08/2020] | ||
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
Refer to Problem Symptoms Table.
-
w/ Canister Pump Module:
Click here
![2019 - 2020 MY RAV4 [11/2018 - 08/2020]; A25A-FKS (ENGINE CONTROL): SFI SYSTEM (w/ Canister Pump Module): PROBLEM SYMPTOMS TABLE](/t3Portal/stylegraphics/info.gif)
-
w/o Canister Pump Module:
Click here
PROCEDURE
1. REMOVE FRONT FENDER SPLASH SHIELD RH
Click here
2. REMOVE FRONT FENDER SPLASH SHIELD LH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
5. INSPECT REAR ENGINE MOUNTING INSULATOR
|
(a) Detach the 2 clamps to disconnect the vacuum hose. |
|
(b) Disconnect the vacuum hose.
|
(c) Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute. |
|
(d) Check that there is no change in the needle movement of the vacuum pump gauge.
OK:
Vacuum pressure holds.
(e) Check that there is no fluid leakage caused by a break in the diaphragm.
(f) Connect the vacuum hose.
(g) Attach the 2 clamps to connect the vacuum hose.
6. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
7. INSTALL NO. 1 ENGINE UNDER COVER
Click here
8. INSTALL FRONT FENDER SPLASH SHIELD LH
Click here
9. INSTALL FRONT FENDER SPLASH SHIELD RH
Click here
|
|