| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001EPGN |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 02/2019] |
| Title: LIGHTING (EXT): HEIGHT CONTROL SENSOR: INSTALLATION; 2019 MY RAV4 RAV4 HV [11/2018 - 02/2019] | ||
INSTALLATION
PROCEDURE
1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
(a) Insert the rear height control sensor bracket into the No. 2 lower arm.
NOTICE:
If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.
|
Insert in this Direction |
(b) Attach the hook.
|
Bolt |
|
Nut |
|
Connector |
(c) Temporarily install the rear height control sensor sub-assembly LH with the bolt and nut.
(d) Tighten the bolt and nut order shown in the illustration.
Torque:
for Bolt :
8.0 N·m {82 kgf·cm, 71 in·lbf}
for Nut :
8.0 N·m {82 kgf·cm, 71 in·lbf}
(e) Connect the connector.
2. PERFORM INITIALIZATION
NOTICE:
If any of the work in the table below has been performed, initialization of the headlight ECU sub-assembly LH is necessary.
|
Performed Work or System Condition |
Necessary Procedures |
Link |
|---|---|---|
|
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components |
Initialization of the headlight ECU sub-assembly LH |
|
3. INSPECT AUTOMATIC LIGHT CONTROL SYSTEM
Click here
![2019 - 2020 MY RAV4 RAV4 HV [11/2018 - 08/2020]; LIGHTING (EXT): LIGHTING SYSTEM (w/ Headlight ECU without AFS): OPERATION CHECK](/t3Portal/stylegraphics/info.gif)
4. INSPECT HEADLIGHT AIMING
-
for Triple Beam Headlight:
Click here
-
for Single Beam Headlight:
Click here
|
|