| Last Modified: 05-08-2025 | 6.11:8.1.0 | Doc ID: RM100000001EPFD |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: REMOVAL; 2019 - 2025 MY RAV4 RAV4 HV [11/2018 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure described below is for the LH side.
PROCEDURE
1. REMOVE DECK BOARD ASSEMBLY
Click here
![2019 MY RAV4 RAV4 HV [11/2018 - 02/2019]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE REAR NO. 3 FLOOR BOARD
Click here
3. REMOVE REAR FLOOR FINISH PLATE
Click here
4. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
Click here
5. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
(a) Remove the rear side of the deck trim side panel assembly LH so that the connector of the rear combination light assembly LH can be disconnected.
Click here
6. REMOVE REAR COMBINATION LIGHT COVER LH
(a) Apply protective tape as shown in the illustration.
|
Place Hands Here |
|
Protective Tape |
|
Remove in this Direction |
(b) Place your hand at the location shown in the illustration and detach the claw to remove the rear combination light cover LH.
7. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
|
(a) Insert your hand between the deck trim side panel assembly LH and the body and disconnect the connector. |
|
(b) Apply protective tape around the rear combination light assembly LH.
|
|
Protective Tape |
|
(c) Remove the 2 screws. |
|
(d) Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and guide to disconnect it.
NOTICE:
Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.
|
*a |
Pin |
|
*b |
Guide |
|
|
Place Hands Here |
|
|
Pull in this Direction |
(e) Remove the grommet and pull out the wire harness.
|
|
Remove in this Direction |
|
|