LIGHTING (EXT): LIGHTING SYSTEM (w/o Headlight ECU): DATA LIST / ACTIVE TEST; 2019 - 2021 MY RAV4 RAV4 HV [11/2018

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001EPCK
Model Year Start: 2019	Model: RAV4	Prod Date Range: [11/2018 - 12/2021]
Title: LIGHTING (EXT): LIGHTING SYSTEM (w/o Headlight ECU): DATA LIST / ACTIVE TEST; 2019 - 2021 MY RAV4 RAV4 HV [11/2018 - 12/2021]

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus:

(1) Body Electrical / Main Body / Data List.

(2) Chassis / Steering Angle Sensor / Data List.

(3) Body Electrical / Combination Meter / Data List.

(4) Body Electrical / Front Recognition Camera (Front Lighting Control) / Data List.

(5) Chassis / Front Recognition Camera / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Main Body > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Auto High Beam Main Switch	Auto high beam switch signal	OFF or ON	OFF: Auto high beam switch not pressed ON: Auto high beam switch pressed	-
Head Light SW (Head)	Light control switch HEAD position signal	OFF or ON	OFF: Light control switch not in HEAD position ON: Light control switch in HEAD position	-
Insolation Amount of Solar Sensor RH	Solar sensor RH condition*1	0 to 51100 or SensorFail	Condition can be displayed	-
Insolation Amount of Solar Sensor LH	Solar sensor LH condition*1	0 to 51100 or SensorFail	Condition can be displayed	-
Light Sensor Illuminance	Light control sensor illuminance*1	0 to 8191 lx or SensorFail	Value is output according to ambient light level	-
Light Sensor Connection Status	Light control sensor connection status*1	OFF or ON	OFF: Automatic light control sensor has not been connected ON: Automatic light control sensor connected or has been connected	-
Headlight Lighting Function	ECU which controls the lighting system	Main Body or Lighting Sys ECU	Main Body: Lighting system controlled by main body ECU (multiplex network body ECU) Lighting Sys ECU: Lighting system is controlled by headlight ECU sub-assembly	-
Sensitivity	Sensitivity of the automatic light control system*1	Light2, Light1, Normal, Dark1 or Dark2	Customize setting displayed	-
DRL Function	Setting of the DRL function on/off*2	OFF or ON	Customize setting displayed	-
Headlight in Conjunction with Wiper	Wiper-linked low beam headlight control*1	OFF or ON	Customize setting displayed	-
Disp Ex ON Sen	Ambient brightness level required to dim display lights (combination meter, navigation display, etc.)*1	Light2, Light1, Normal, Dark1 or Dark2	Customize setting displayed	-
Disp Ex OFF Sen	Ambient brightness level required to cancel dimming display lights (combination meter, navigation display, etc.)*1	Light2, Light1, Normal, Dark1 or Dark2	Customize setting displayed	-
Light Auto OFF Delay	Light auto OFF delay	Off, 30 s, 60 s or 90 s	Customize setting displayed	-
Auto H Beam STS0	Automatic high beam sensor current state	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	If the value of this item is not as specified, the automatic high beam sensor system may be malfunctioning.
Auto H Beam STS1	Automatic high beam sensor state past 1	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Auto H Beam STS2	Automatic high beam sensor state past 2	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Auto H Beam STS3	Automatic high beam sensor state past 3	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Auto H Beam STS4	Automatic high beam sensor state past 4	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Auto H Beam STS5	Automatic high beam sensor state past 5	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Auto H Beam STS6	Automatic high beam sensor state past 6	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Auto H Beam STS7	Automatic high beam sensor state past 7	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc, Delay, Aim Lmt, SAE Mod, Undefin or LIN Err	Condition can be displayed*3	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Tail Remind Buzzer Function	Setting of the tail remind buzzer function on/off	OFF or ON	Customize setting displayed	-
The Number of DTC	Number of trouble codes	0 to 255	Number of stored DTCs displayed	-

*1: w/ Automatic Light Control System
*2: for vehicles with customize setting "DRL Function"

HINT:

*3: The details of each value of the Range are as follows:

Display Value	Condition	Control Condition	Diagnostic Note
Undetec	Automatic high beam sensor being initialized	Control suspended (low beam headlights illuminated)	-
CAM NA	Automatic high beam sensor temporarily disabled due to high temperature, unclear image (due to dirt, fog, etc.), etc.	Control suspended (low beam headlights illuminated)	-
No sens	No lights detected	High beam headlights illuminated	Only when vehicle speed within operation speed range
Hlight	Headlights of oncoming vehicle, etc. detected	Low beam headlights illuminated	Only when vehicle speed within operation speed range
Taillgt	Taillights preceding vehicle, etc. detected	Low beam headlights illuminated	Only when vehicle speed within operation speed range
Speed	No lights detected and vehicle speed below operation speed	Low beam headlights illuminated	-
Daytime	Bright light detected	Low beam headlights illuminated	-
Village	Streetlights, etc. detected	Low beam headlights illuminated	Only when vehicle speed within operation speed range
Delay	Changing between low beams and high beams	Changing between low beams and high beams	Only when vehicle speed within operation speed range
SAE Mod	Not applicable	-	-
Malfunc
Aim Lmt
Undefin
LIN Err

Chassis > Steering Angle Sensor > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Light OFF Switch	Light control switch DRL OFF1 or OFF2 position signal	OFF or ON	OFF: Light control switch not in DRL OFF1 or OFF2 position ON: Light control switch in DRL OFF1 or OFF2 position	-
Auto Light Switch	Light control switch AUTO3 or DRL4 position signal	OFF or ON	OFF: Light control switch not in AUTO3 or DRL4 position ON: Light control switch in AUTO3 or DRL4 position	-
Head Light Switch (Tail)	Light control switch TAIL position signal	OFF or ON	OFF: Light control switch not in TAIL position ON: Light control switch in TAIL position	-
Head Light Switch (Head)	Light control switch HEAD position signal	OFF or ON	OFF: Light control switch not in HEAD position ON: Light control switch in HEAD position	-
High Beam Main Switch	Headlight dimmer switch High position signal	OFF or ON	OFF: Headlight dimmer switch not in High position ON: Headlight dimmer switch in High position	-
Passing Light Switch	Headlight dimmer switch Flash position (pass) signal	OFF or ON	OFF: Headlight dimmer switch not in Flash position ON: Headlight dimmer switch in Flash position	-
Auto High Beam Main Switch	Auto high beam switch signal	OFF or ON	OFF: Auto high beam switch off ON: Auto high beam switch on	Although the item is displayed on the Techstream, it is not applicable to the vehicle.
Turn Signal Switch (Right)	Turn signal switch (right turn position) signal	OFF or ON	OFF: Turn signal switch not in right turn position ON: Turn signal switch in right turn position	-
Turn Signal Switch (Left)	Turn signal switch (left turn position) signal	OFF or ON	OFF: Turn signal switch not in left turn position ON: Turn signal switch in left turn position	-
Cornering Light/Front Side Illuminate Light Switch	Turn signal switch (full turn) signal	OFF or ON	OFF: Turn signal switch not in left or right turn position ON: Turn signal switch in left or right full turn position	-
Front Fog Light Switch	Fog light switch (front position) signal*5	OFF or ON	OFF: Fog light switch in OFF position ON: Fog light switch in Fr position	-
Rear Fog Light/Bad Weather Switch	Fog light switch (rear position) signal*5	OFF or ON	OFF: Fog light switch in OFF position ON: Fog light switch in Rr position	Although the item is displayed on the Techstream, it is not applicable to the vehicle.
Automatic Light Equipped Info	Automatic light control system specification information	Unknown, With or Without	Unknown: Specification not stored With: Automatic light control system equipped Without: Automatic light control system not equipped	-
Bad Weather Mode Equipped Info	Bad weather specification information	Unknown, Without or With	Unknown: Specification not stored Without: Bad weather specification not equipped With: Bad weather specification equipped	Although the item is displayed on the Techstream, it is not applicable to the vehicle.
The Number of DTCs	Number of trouble codes	0 to 255	Number of stored DTCs displayed	-

*1: w/ DRL OFF Switch
*2: w/ Light Control Switch OFF Position
*3: w/ Automatic Light Control System
*4: w/ DRL Switch
*5: w/ Front Fog Light

Body Electrical > Combination Meter > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Hazard Flasher Switch

Hazard warning signal switch signal

OFF or ON

OFF: Hazard warning signal switch off

ON: Hazard warning signal switch on

Lane Change Flashing Times Adjust

Condition of the lane change flashing times

OFF, 3, 4, 5, 6 or 7

Customize setting displayed

Body Electrical > Front Recognition Camera (Front Lighting Control) > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Total Distance Traveled	Actual driving distance	0 to 16777215	Roughly the same as the actual driving distance	-
Total Distance Traveled - Unit	Actual driving distance unit	km or mile	Displays the current actual driving distance unit	-
AHB/AHS Information	Lighting system state	unknown, AHB or AHS	Displays lighting system state	-

Chassis > Front Recognition Camera > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Front Recognition Camera High Temperature 2

Whether high temperature malfunction of forward recognition camera exists or not

Not High Temperature or High Temperature

Not High Temperature: Approximately 65°C (149°F) or less

High Temperature: Approximately 65°C (149°F) or higher

If this item is "High Temperature", the automatic high beam system will be temporarily unavailable. If this does not improve even if the inside of the vehicle is left cooled for at least 10 minutes, the forward recognition camera may be malfunctioning.

HINT:

In summertime, the windshield glass may reach 100°C (212°F) or higher

ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus:

(1) Body Electrical / Main Body / Active Test.

(2) Body Electrical / Combination Meter / Active Test.

(e) Perform the Active Test according to the display on the Techstream.

Body Electrical > Main Body > Active Test

Tester Display	Measurement Item	Control Range	Diagnostic Note
Daytime Running Light	Daytime running lights	OFF or ON	-
Side Mirror Foot Light	Foot lights*1	OFF or ON	-
Taillight Relay	Taillight relay	OFF or ON	-
Headlight Relay	Low beam headlights	OFF or ON	-
Head Light Hi	High beam headlights	OFF or ON	-
Front Fog Light Relay	Front fog light relay*2	OFF or ON	Light control switch in TAIL position
Rear Fog Light Relay	Rear fog light relay	OFF or ON	Although this item is displayed on the Techstream, it is not applicable to this vehicle.
Dimmer Signal	Dimmer signal	OFF or ON	State where circumference illumination is bright
Automatic High Beam Switch Light	Auto high beam switch indicator light	OFF or ON	-

*1: w/ Foot Light
*2: w/ Front Fog Light

Body Electrical > Combination Meter > Active Test

Tester Display	Measurement Item	Control Range	Diagnostic Note
Multi Display All (White)	Multi-information display (White display)	OFF or ON	-
Automatic High Beam Indicator (Green)	Automatic high beam indicator	OFF or ON	-