| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001EFBT |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: NETWORKING: NETWORK GATEWAY ECU: INSTALLATION; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL NETWORK GATEWAY ECU
(a) Attach the claw to install the network gateway ECU.
|
Install in this Direction |
2. INSTALL ECU INTEGRATION BOX RH
(a) Install the ECU integration box RH with the nut and bolt.
|
Nut |
|
Bolt |
Torque:
Nut :
5.5 N·m {56 kgf·cm, 49 in·lbf}
Bolt :
5.5 N·m {56 kgf·cm, 49 in·lbf}
|
(b) Attach the 3 wire harness clamps. |
|
(c) Connect the 4 connectors.
|
(d) Attach the claw and relay holder. |
|
|
(e) w/ Clearance Warning System: (1) Connect the connector. |
|
3. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
![2019 - 2020 MY RAV4 RAV4 HV [11/2018 - 08/2020]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. INSTALL COWL SIDE TRIM BOARD RH
Click here
7. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure described for the LH side.
Click here
8. INSTALL CONSOLE BOX ASSEMBLY
Click here
9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
-
for A25A-FKS:
Click here
-
for A25A-FXS:
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
10. INSTALL BATTERY HOLE COVER (for HV Model)
Click here
11. INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
Click here
12. INSTALL DECK BOARD ASSEMBLY (for HV Model)
Click here
|
|