SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION; 2019 - 2020 MY RAV4 RAV4 HV [11/2018

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001EBT1
Model Year Start: 2019	Model: RAV4	Prod Date Range: [11/2018 - 08/2020]
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION; 2019 - 2020 MY RAV4 RAV4 HV [11/2018 - 08/2020]

INSTALLATION

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

Install in this Direction

(d) Install the 2 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

(e) Connect the airbag connector and push the lock button to lock.

*a	Lock Button
	Push in this Direction

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.

(f) Check that there is no looseness in the lower No. 1 instrument panel airbag assembly.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Click here

3. INSTALL CONSOLE BOX ASSEMBLY

Click here

4. INSTALL FUSE BOX OPENING COVER

Click here

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

6. INSTALL COWL SIDE TRIM BOARD LH

Click here

7. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

9. INSTALL BATTERY HOLE COVER (for HV Model)

Click here

10. INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)

Click here

11. INSTALL DECK BOARD ASSEMBLY (for HV Model)

Click here

12. PERFORM DIAGNOSTIC SYSTEM CHECK

13. CHECK SRS WARNING LIGHT

14. PERFORM SYSTEM INITIALIZATION AND CALIBRATION

Click here