| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001E7MJ |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: PARK ASSIST / MONITORING: CLEARANCE WARNING BUZZER (for Rear Side): REMOVAL; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] | ||
REMOVAL
PROCEDURE
1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Click here
![2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ]; SEAT: REAR SEAT ASSEMBLY: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE REAR SEAT CUSHION LOCK HOOK
Click here
3. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (FLOOR ANCHOR)
Click here
4. REMOVE REAR SEATBACK ASSEMBLY RH
Click here
5. REMOVE REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure described for the LH side.
Click here
6. REMOVE NO. 2 BATTERY SERVICE COVER BOARD (for HV Model)
Click here
7. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
Click here
8. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
Click here
9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
- Use the same procedure described for the LH side.
- Pull back the rear door opening trim weatherstrip RH so that the rear seat side garnish RH can be removed.
HINT:
Click here
10. REMOVE REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure described for the LH side.
Click here
11. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Click here
12. REMOVE DECK BOARD ASSEMBLY
Click here
13. REMOVE REAR NO. 2 FLOOR BOARD
Click here
14. REMOVE REAR FLOOR FINISH PLATE
Click here
15. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
Click here
16. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
Click here
17. REMOVE TETHER ANCHOR BRACKET SET
Click here
18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
19. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
Click here
20. REMOVE NO. 2 CLEARANCE WARNING BUZZER
HINT:
Perform the following procedure only when replacement of a No. 2 clearance warning buzzer is necessary.
(a) Using a clip remover, detach the clamp and remove the No. 2 clearance warning buzzer.
|
Protective Tape |
HINT:
Tape the clip remover tip before use.
(b) Disconnect the connector.
|
|