| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001E7JE |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 10/2019] |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Data Signal Circuit between Radio Receiver and Stereo Jack Adapter; 2019 MY RAV4 RAV4 HV [11/2018 - 10/2019] | ||
|
Data Signal Circuit between Radio Receiver and Stereo Jack Adapter |
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
|
(a) Disconnect the G106 radio and display receiver assembly connector. |
|
(b) Disconnect the G16 No. 1 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G106-2 (US1-) - G16-9 (UDO-) |
Always |
Below 1 Ω |
|
G106-3 (US1+) - G16-10 (UDO+) |
Always |
Below 1 Ω |
|
G106-5 (USG1) - G16-12 (UJSS) |
Always |
Below 1 Ω |
|
G106-2 (US1-) or G16-9 (UDO-) - Body ground |
Always |
10 kΩ or higher |
|
G106-3 (US1+) or G16-10 (UDO+) - Body ground |
Always |
10 kΩ or higher |
|
G106-5 (USG1) or G16-12 (UJSS) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
![2019 MY RAV4 RAV4 HV [11/2018 - 02/2019]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: PROBLEM SYMPTOMS TABLE](/t3Portal/stylegraphics/info.gif)
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|