Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001E4Y6 |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 - 10/2022] |
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B1585; USB Device Malfunction; 2019 - 2022 MY RAV4 RAV4 HV [11/2018 - 10/2022] |
DTC
|
B1585
|
USB Device Malfunction
|
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B1585
|
USB Device Malfunction
|
When any of the following conditions is met:
-
A non mass-storage class or incompatible protocol USB device connected
-
USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) connected
-
"iPod" malfunction
-
"iPod" with unsupported firmware connected
-
Unsupported "iPod" model connected
|
-
USB device or "iPod"
-
Radio and display receiver assembly
|
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio and display receiver assembly may not operate normally.
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
1.
|
REPLACE USB DEVICE OR "iPod"
|
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
(b) Turn the ignition switch off.
HINT:
When this DTC has been stored, it is necessary to turn the ignition switch off to make it possible for the vehicle to recognize a new device when it is connected.
(c) Turn the ignition switch to ACC.
(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
-
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
-
Refer to System Description for compatible formats and versions.
Click here
NEXT
|
|
|
(a) Clear the DTCs.
Click here
Body Electrical > Navigation System > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Click here
Body Electrical > Navigation System > Trouble Codes
OK:
No DTCs are output.
OK |
|
END (USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE)
|
|