Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001YPLM |
Model Year Start: 2022 |
Model: Avalon HV |
Prod Date Range: [08/2021 -
] |
Title: A25A-FXS (EMISSION CONTROL): EGR COOLER: REMOVAL; 2022 MY Avalon HV [08/2021 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedures
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Auxiliary battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting System (for HV Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
Replacement of inverter with converter assembly
|
Resolver learning
|
-
DTCs are stored
-
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
-
Shock or vibration during acceleration
|
|
Replacement of ECM
|
Perform Vehicle Identification Number (VIN) registration
|
MIL comes on
|
|
Gas leak from exhaust system is repaired
|
Inspection After Repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
PROCEDURE
1. DRAIN ENGINE COOLANT (for Engine)
Click here
2. REMOVE INVERTER WITH CONVERTER ASSEMBLY
Click here
3. REMOVE EGR COOLER ASSEMBLY
(a) Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.
|
|
*1
|
No. 3 Water By-pass Hose
|
*2
|
No. 4 Water By-pass Hose
|
|
|
(b) Type A:
(1) Remove the 3 bolts, 2 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.
|
|
(c) Type B:
(1) Remove the 2 bolts, 3 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.
(d) Remove the EGR valve gasket from the EGR cooler assembly.
|
|
*1
|
EGR Valve Gasket
|
*2
|
EGR Cooler Gasket
|
|
|
(e) Remove the EGR cooler gasket from the EGR cooler assembly.
|