Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001YOO7 |
Model Year Start: 2022 |
Model: Avalon HV |
Prod Date Range: [08/2021 -
] |
Title: SEAT: REAR SEAT RECLINING CONTROL CABLE: REMOVAL; 2022 MY Avalon Avalon HV [08/2021 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback lock assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting system (for Gasoline Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
CAUTION:
-
Wear protective gloves. Sharp areas on the parts may injure your hands.
-
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting system (for HV Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
CAUTION:
-
Wear protective gloves. Sharp areas on the parts may injure your hands.
-
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE REAR SEAT ASSEMBLY
Click here
2. REMOVE CENTER STOP LIGHT SET
Click here
3. REMOVE LUGGAGE COMPARTMENT INNER TRIM PAD (w/o Seat Heater System)
(a) Remove the luggage compartment inner trim pad.
|
|
4. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
Click here
5. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Click here
7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
Use the same procedure as for the LH side.
8. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH
Click here
9. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
10. REMOVE ROOF SIDE INNER GARNISH LH
Click here
11. REMOVE ROOF SIDE INNER GARNISH RH
HINT:
Use the same procedure as for the LH side.
12. REMOVE REAR SEAT SHOULDER BELT COVER
Click here
13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
Click here
14. REMOVE ROOM PARTITION BOARD LH
(b) Disengage the 2 claws.
|
|
(c) Disengage the 4 clips to remove the room partition board LH.
15. REMOVE ROOM PARTITION BOARD RH
(b) Disengage the 5 clips to remove the room partition board RH.
|
|
16. REMOVE REAR SEATBACK LOCK ASSEMBLY LH
(a) Release the stopper and disengage the guide as shown in the illustration.
*a
|
Stopper
|
|
Release
|
|
Remove in this Direction (1)
|
|
Remove in this Direction (2)
|
(b) Remove the 2 nuts and rear seatback lock assembly LH.
|
|
17. REMOVE REAR SEATBACK LOCK ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
|