Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001YOEN |
Model Year Start: 2022 |
Model: Avalon HV |
Prod Date Range: [08/2021 -
] |
Title: HYBRID / BATTERY CONTROL: HYBRID VEHICLE CONTROL ECU: REMOVAL; 2022 MY Avalon HV [08/2021 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting System (for HV Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
Replacement of hybrid vehicle control ECU
|
Code registration (Smart key System (for Start Function))
|
-
Wireless door lock control system
-
Smart key system (for Entry Function)
-
Smart key system (for Start Function)
-
Steering lock function
|
|
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here
NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click here
PROCEDURE
1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
2. REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
Click here
3. REMOVE HYBRID VEHICLE CONTROL ECU
(a) Disconnect the 4 hybrid vehicle control ECU connectors.
|
|
(b) Remove the bolt, nut and hybrid vehicle control ECU.
|
|
|