| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001YNLB |
| Model Year Start: 2022 | Model: Avalon HV | Prod Date Range: [08/2021 - ] |
| Title: AUDIO / VIDEO: STEREO COMPONENT AMPLIFIER: REMOVAL; 2022 MY Avalon Avalon HV [08/2021 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here
|
|||
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision System |
|||
|
Intelligent Clearance Sonar System* |
|||
|
Lighting System (for Gasoline Model with Cornering Light) |
|||
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
|
Panoramic View Monitor System |
|
||
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
![2021 - 2022 MY Avalon [08/2020 - ]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM (for Gasoline Model): PRECAUTION](/t3Portal/stylegraphics/info.gif)
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here
|
|||
|
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision System |
|||
|
Intelligent Clearance Sonar System* |
|||
|
Lighting System (for HV Model with Cornering Light) |
|||
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
|
Panoramic View Monitor System |
|
||
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
Click here
2. REMOVE AUDIO AMPLIFIER COVER
|
(a) Remove the 3 clips and audio amplifier cover. |
|
3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET
|
(a) Disconnect each connector. |
|
(b) Disengage the clamp.
|
(c) Turn back the front floor carpet assembly and front floor mat as shown in the illustration. |
|
|
(d) Remove the bolt. |
|
(e) Disengage the 2 guides and remove the stereo component amplifier assembly with bracket as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
4. REMOVE NO. 1 AMPLIFIER BRACKET
|
(a) Remove the 2 screws. |
|
(b) Disengage the guide to remove the No. 1 amplifier bracket.
5. REMOVE NO. 2 AMPLIFIER BRACKET
|
(a) Remove the 2 screws and No. 2 amplifier bracket. |
|
6. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY
|
|