Last Modified: 08-21-2023 6.11:8.1.0 Doc ID: RM100000001YL6P
Model Year Start: 2022 Model: Avalon HV Prod Date Range: [08/2021 -           ]
Title: A25A-FXS (ENGINE CONTROL): ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL; 2022 MY Avalon HV [08/2021 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link
*: When performing learning using the Techstream.

Click here 2019 - 2022 MY Avalon HV [04/2018 -        ]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM (for HV Model): CALIBRATION

Auxiliary battery terminal is disconnected/reconnected

Perform steering sensor zero point calibration

Lane Tracing Assist System

2022 MY Avalon Avalon HV [08/2021 -        ]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision System

Intelligent Clearance Sonar System*

Lighting System (for HV Model with Cornering Light)

Memorize steering angle neutral point

Parking Assist Monitor System

2019 - 2022 MY Avalon HV [04/2018 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM(for HV Model): INITIALIZATION

Panoramic View Monitor System

2019 - 2022 MY Avalon HV [04/2018 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): INITIALIZATION

Replacement of inverter with converter assembly

Resolver learning
  • DTCs are stored
  • Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
  • Shock or vibration during acceleration

2021 - 2022 MY Avalon HV [08/2020 -        ]; HYBRID / BATTERY CONTROL: MOTOR GENERATOR CONTROL SYSTEM (for LITHIUM-ION BATTERY): UTILITY

Replacement of ECM

Perform Vehicle Identification Number (VIN) registration

MIL illuminates

2019 - 2022 MY Avalon HV [04/2018 -        ]; A25A-FXS (ENGINE CONTROL): SFI SYSTEM: REGISTRATION

Replacement of engine coolant temperature sensor

Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.

2022 MY Avalon HV [08/2021 -        ]; A25A-FXS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

PROCEDURE

1. DRAIN ENGINE COOLANT (for Engine)

Click here 2019 - 2022 MY Avalon HV [04/2018 -        ]; MAINTENANCE: A25A-FXS COOLANT (for Engine): REPLACEMENT+

2. REMOVE COOL AIR INTAKE DUCT SEAL

Click here 2022 MY Avalon Avalon HV [08/2021 -        ]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL+

3. REMOVE INLET AIR CLEANER ASSEMBLY

Click here 2022 MY Avalon HV [08/2021 -        ]; HYBRID / BATTERY CONTROL: INVERTER WITH CONVERTER: REMOVAL+

4. REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR

(a) Disconnect the No. 2 engine coolant temperature sensor connector.

(b) Remove the clip and No. 2 engine coolant temperature sensor from the radiator pipe.

NOTICE:

If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.

5. REMOVE INVERTER WITH CONVERTER ASSEMBLY

Click here 2022 MY Avalon HV [08/2021 -        ]; HYBRID / BATTERY CONTROL: INVERTER WITH CONVERTER: REMOVAL

6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

(a) Disconnect the engine coolant temperature sensor connector.

(b) Remove the clip and engine coolant temperature sensor from the water outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.