Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001YKTP |
Model Year Start: 2022 |
Model: Avalon HV |
Prod Date Range: [08/2021 -
] |
Title: CELLULAR COMMUNICATION: TELEPHONE AND GPS ANTENNA CORDS: REMOVAL; 2022 MY Avalon Avalon HV [08/2021 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone and GPS antenna cord removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision System
|
Intelligent Clearance Sonar System*
|
Lighting System (for Gasoline Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic View Monitor System
|
|
Front passenger seat
|
Zero point calibration (Occupant classification system)
|
-
Occupant classification system
-
Passenger airbag ON/OFF indicator
-
Airbag system (Front passenger side)
-
Seat belt warning system (Front passenger)
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision System
|
Intelligent Clearance Sonar System*
|
Lighting System (for HV Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic View Monitor System
|
|
Front passenger seat
|
Zero point calibration (Occupant classification system)
|
-
Occupant classification system
-
Passenger airbag ON/OFF indicator
-
Airbag system (Front passenger side)
-
Seat belt warning system (Front passenger)
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for Front Side)
Click here
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH (for Front Side)
Click here
3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (for Front Side)
Click here
4. REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY (for Front Side)
Click here
5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for Front Side)
Click here
6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for Front Side)
Click here
7. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL (for Front Side)
Click here
8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Front Side)
Click here
9. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for Front Side)
Click here
10. REMOVE DCM (TELEMATICS TRANSCEIVER) WITH BRACKET (for Front Side)
Click here
11. REMOVE TELEPHONE AND GPS ANTENNA CORD (for Front Side)
(a) w/o Navigation System:
(2) Disconnect the 3 connectors to remove the telephone and GPS antenna cord.
(b) w/ Navigation System:
(2) Disconnect the 3 connectors to remove the telephone and GPS antenna cord.
12. REMOVE ROOF HEADLINING ASSEMBLY (for Roof Side)
Click here
13. REMOVE TELEPHONE AND GPS ANTENNA CORD (for Roof Side)
(a) Disconnect the connector.
|
|
(b) Disengage the 4 clamps to remove the telephone and GPS antenna cord.
|