| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001Y3VF |
| Model Year Start: 2022 | Model: Avalon HV | Prod Date Range: [08/2021 - ] |
| Title: CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: INSTALLATION; 2022 MY Avalon Avalon HV [08/2021 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
NOTICE:
If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
(a) Engage the 2 guides.
|
Bolt |
|
Screw |
(b) Tighten the 2 bolts and screw on the millimeter wave radar sensor assembly.
Torque:
Bolt :
2.5 N·m {25 kgf·cm, 22 in·lbf}
NOTICE:
Do not overtighten the screw. The radiator grille sub-assembly may be damaged.
HINT:
Tighten the bolts and screw in the order shown in the illustration.
(c) Connect the connector.
2. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
![2022 MY Avalon Avalon HV [08/2021 - ]; EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. ADJUST MILLIMETER WAVE RADAR SENSOR
(a) When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
HINT:
Millimeter wave radar sensor assembly learning can be performed by using either Target Adjustment (Triangle Target) or Target Adjustment (Flat Surface Target) or Driving Adjustment.
Target Adjustment (Triangle Target): Click here
Target Adjustment (Flat Surface Target):Click here
Driving Adjustment: Click here
|
|