Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001Y0FL |
Model Year Start: 2022 |
Model: Avalon HV |
Prod Date Range: [08/2021 -
] |
Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION; 2022 MY Avalon Avalon HV [08/2021 - ] |
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
TARGET ADJUSTMENT(TRIANGLE TARGET):
Click here
TARGET ADJUSTMENT(FLAT SURFACE TARGET):
Click here
DRIVING ADJUSTMENT:
Click here
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) Move the front bumper assembly into position and engage the 2 guides as shown in the illustration.
|
Install in this Direction
|
(b) Install the 4 bolts.
(c) w/ Intuitive Parking Assist System:
(1) Connect the connector.
(d) Connect the connector.
(e) Engage the 4 claws as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
|
Install in this Direction
|
(f) Install the 8 screws.
(g) Install the screw.
HINT:
Use the same procedure for the RH side and LH side.
(h) Install the front bumper assembly with the 2 clips.
HINT:
Use the same procedure for the RH side and LH side.
2. INSTALL COOL AIR INTAKE DUCT SEAL
(a) Engage the guide as shown in the illustration.
|
Install in this Direction (1)
|
|
Install in this Direction (2)
|
(b) Install the cool air intake duct seal with the 7 clips.
3. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
for HV Model:
Click here
for Gasoline Model:
Click here
4. PERFORM CALIBRATION (w/ Intelligent Clearance Sonar System)
for HV Model:
Click here
for Gasoline Model:
Click here
5. ADJUST HEADLIGHT AIMING
HINT:
Perform this procedure only when the front bumper reinforcement has been replaced.
Click here
|