| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001RG4I |
| Model Year Start: 2021 | Model: Avalon HV | Prod Date Range: [08/2020 - ] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): INSTALLATION; 2021 - 2022 MY Avalon Avalon HV [08/2020 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.
(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
(c) Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
|
*a |
Airbag Connector |
|
*b |
Airbag Connector Locking Button |
|
Push in this Direction |
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(d) Push in the airbag connector locking button to install the airbag connector.
|
(e) Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly. |
|
(f) Engage the 2 claws.
(g) Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
![2019 - 2022 MY Avalon Avalon HV [04/2018 - ]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here
4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. INSTALL INSTRUMENT SIDE PANEL LH
Click here
7. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
9. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
10. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2GR-FKS: Click here
for A25A-FXS: Click here
for A25A-FKS: Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
11. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model)
Click here
12. PERFORM DIAGNOSTIC SYSTEM CHECK
for Gasoline Model: Click here
for HV Model: Click here
13. INSPECT SRS WARNING LIGHT
for Gasoline Model: Click here
for HV Model: Click here
|
|