Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001PY6B |
Model Year Start: 2021 |
Model: Avalon HV |
Prod Date Range: [08/2020 -
] |
Title: CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15C111,B15C113; GNSS Antenna Circuit Short to Ground; 2021 - 2022 MY Avalon Avalon HV [08/2020 - ] |
DTC
|
B15C111
|
GNSS Antenna Circuit Short to Ground
|
DTC
|
B15C113
|
GNSS Antenna Circuit Open
|
DESCRIPTION
These DTCs are stored when a malfunction occurs in the telephone and GPS antenna (for Roof Side) circuit.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B15C111
|
GNSS Antenna Circuit Short to Ground
|
Current to the GNSS antenna is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
(Short circuit)
|
-
DCM (telematics transceiver)
-
Telephone and GPS antenna assembly (for Roof Side)
-
Telephone and GPS antenna cord (No. 2 antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 3 antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 4 antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 6 antenna cord sub-assembly)
|
B15C113
|
GNSS Antenna Circuit Open
|
Current to the GNSS antenna is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
(Open circuit)
|
-
DCM (telematics transceiver)
-
Telephone and GPS antenna assembly (for Roof Side)
-
Telephone and GPS antenna cord (No. 2 antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 3 antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 4 antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 6 antenna cord sub-assembly)
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
HINT:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Click here
-
Refer to "PARTS LOCATION" for the installation location of telephone and GPS antenna cord.
Click here
PROCEDURE
(a) Turn the ignition switch off.
(b) Connect the GTS to the DLC3.
(c) Turn the ignition switch to ON and wait for 10 seconds or more.
(d) Turn the GTS on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
(f) Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK:
No DTCs are output.
NG
|
|
|
2.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the K telephone and GPS antenna cord (No. 2 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the J telephone and GPS antenna cord (No. 2 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
K-2 - J-2
|
Always
|
Below 1 Ω
|
K-2 or J-2 - Body ground
|
Always
|
10 kΩ or higher
|
K-2a - J-2a
|
Always
|
Below 1 Ω
|
K-2a or J-2a - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
3.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 3 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the I telephone and GPS antenna cord (No. 3 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 3 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the H telephone and GPS antenna cord (No. 3 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 3 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
I-2 - H-2
|
Always
|
Below 1 Ω
|
I-2 or H-2 - Body ground
|
Always
|
10 kΩ or higher
|
I-2a - H-2a
|
Always
|
Below 1 Ω
|
I-2a or H-2a - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
4.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 4 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the G telephone and GPS antenna cord (No. 4 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 4 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the E telephone and GPS antenna cord (No. 4 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 4 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G-2 - E-2
|
Always
|
Below 1 Ω
|
G-2 or E-2 - Body ground
|
Always
|
10 kΩ or higher
|
G-2a - E-2a
|
Always
|
Below 1 Ω
|
G-2a or E-2a - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
5.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 6 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the D telephone and GPS antenna cord (No. 6 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 6 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the B telephone and GPS antenna cord (No. 6 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 6 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
D-2 - B-1
|
Always
|
Below 1 Ω
|
D-2 or B-1 - Body ground
|
Always
|
10 kΩ or higher
|
D-2a - B-1a
|
Always
|
Below 1 Ω
|
D-2a or B-1a - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
6.
|
CHECK TELEPHONE AND GPS ANTENNA (for Roof Side)
|
(a) Replace the telephone and GPS antenna (for Roof Side) with a known good one.
Click here
(b) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
(c) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK:
No DTCs are output.
OK |
|
END (TELEPHONE AND GPS ANTENNA (for Roof Side) IS DEFECTIVE)
|
NG
|
|
|
7.
|
REPLACE DCM (TELEMATICS TRANSCEIVER)
|
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
-
The ignition switch must be off.
-
Do not exchange the DCM (telematics transceiver) with one from another vehicle.
|