| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001PX44 |
| Model Year Start: 2021 | Model: Avalon | Prod Date Range: [08/2020 - ] |
| Title: A25A-FKS (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: INSTALLATION; 2021 - 2022 MY Avalon [08/2020 - ] | ||
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
![2019 - 2022 MY Avalon Avalon HV [04/2018 - ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. INSTALL CRANKSHAFT POSITION SENSOR
|
*a |
O-ring Groove |
|
*b |
Crankshaft Position Sensor Tip |
(a) Perform this procedure only when reusing the crankshaft position sensor.
(1) Clean the O-ring groove of the crankshaft position sensor.
NOTICE:
Make sure the O-ring groove is free of foreign matter.
(2) Install a new O-ring to the crankshaft position sensor.
NOTICE:
Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.
|
(3) Check if the O-ring is twisted. HINT: Check the entire circumference of the seam of the O-ring for twisting. |
|
(b) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
(c) Using an 8 mm socket wrench, install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
- If the crankshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
(d) Connect the crankshaft position sensor connector.
2. INSTALL STARTER ASSEMBLY
Click here
|
|