- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001PX3Y |
| Model Year Start: 2021 | Model: Avalon | Prod Date Range: [08/2020 - ] |
| Title: A25A-FKS (ENGINE CONTROL): MASS AIR FLOW METER: REMOVAL; 2021 - 2022 MY Avalon [08/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during mass air flow meter sub-assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Replacement of mass air flow meter sub-assembly |
Inspection after repair |
|
|
![2021 - 2022 MY Avalon [08/2020 - ]; A25A-FKS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. REMOVE MASS AIR FLOW METER SUB-ASSEMBLY
|
(a) Disconnect the mass air flow meter sub-assembly connector. |
|
(b) Remove the 2 screws and mass air flow meter sub-assembly from the air cleaner cap sub-assembly.
NOTICE:
If the mass air flow meter sub-assembly has been struck or dropped, replace it.
|
|