Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001PTJ6 |
Model Year Start: 2021 |
Model: Avalon |
Prod Date Range: [08/2020 -
] |
Title: MAINTENANCE: A25A-FKS BATTERY: REMOVAL; 2021 - 2022 MY Avalon [08/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Departure Alert System (w/ Steering Control)
|
|
Pre-collision System
|
Intelligent Clearance Sonar System*1
|
Lighting System (for Gasoline Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic View Monitor System
|
|
PROCEDURE
1. PRECAUTION
NOTICE:
-
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
-
When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(a) Loosen the nut, and disconnect the cable from the negative (-) battery terminal.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
|
|
3. REMOVE BATTERY
(a) Disengage the 2 claws and remove the battery terminal cap from the positive (+) battery terminal in the order shown in the illustration.
*a
|
Side View of Claws
|
|
Push Battery Terminal Cap Here
|
|
Push
|
(b) Loosen the nut and disconnect the cable from the positive (+) battery terminal.
|
|
(c) Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.
|
Remove in this Direction
|
(d) Remove the battery from the vehicle.
|