Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001BE2L |
Model Year Start: 2019 |
Model: Avalon HV |
Prod Date Range: [04/2018 - 08/2021] |
Title: CRUISE CONTROL: FRONT CAMERA SYSTEM (for HV Model): HOW TO PROCEED WITH TROUBLESHOOTING; 2019 - 2021 MY Avalon HV [04/2018 - 08/2021] |
HOW TO PROCEED WITH TROUBLESHOOTING
|
CAUTION / NOTICE / HINT
HINT:
-
Use these procedures to troubleshoot the front camera system.
-
*: Use the Techstream.
PROCEDURE
1.
|
VEHICLE BROUGHT TO WORKSHOP
|
NEXT
|
|
|
2.
|
INSPECT AUXILIARY BATTERY VOLTAGE
|
(a) Measure the auxiliary battery voltage with the power switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.
NEXT
|
|
|
3.
|
CHECK CAN COMMUNICATION SYSTEM*
|
(a) Using the Techstream, check if the CAN communication system is functioning normally.
HINT:
Refer to CAN Bus Check in CAN Communication System.
Click here
OK:
CAN communication system is functioning normally.
OK
|
|
|
HINT:
Refer to DTC Check / Clear.
Click here
(a) Check for DTCs and note any codes that are output.
Chassis > Front Recognition Camera > Trouble Codes
(b) Clear the DTCs.
Chassis > Front Recognition Camera > Clear DTCs
(c) Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.
Chassis > Front Recognition Camera > Trouble Codes
Result
|
Proceed to
|
DTCs are not output
|
A
|
DTCs are output
|
B
|
A
|
|
|
5.
|
PROBLEM SYMPTOMS TABLE
|
HINT:
Refer to Problem Symptoms Table.
Click here
Result
|
Proceed to
|
Fault is not listed in Problem Symptoms Table
|
A
|
Fault is listed in Problem Symptoms Table
|
B
|
A
|
|
|
6.
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
|
(a) Terminals of ECU
Click here
(b) Data List / Active Test
Click here
NEXT
|
|
|
7.
|
ADJUST, REPAIR OR REPLACE
|
NOTICE:
If the forward recognition camera has been replaced with a new one, it is necessary to perform forward recognition camera adjustment.
Click here
NEXT
|
|
|
NEXT |
|
END
|
|