Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001B4NY |
Model Year Start: 2019 |
Model: Avalon |
Prod Date Range: [04/2018 - 08/2021] |
Title: 2GR-FKS (FUEL): FUEL PUMP ECU: REMOVAL; 2019 - 2021 MY Avalon [04/2018 - 08/2021] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Departure Alert System (w/ Steering Control)
|
|
Pre-collision System
|
Intelligent Clearance Sonar System*
|
Lighting System (for Gasoline Model with Cornering Light)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic View Monitor System
|
|
PROCEDURE
1. REMOVE REAR SEAT ASSEMBLY
Click here
2. REMOVE CENTER STOP LIGHT SET
Click here
3. REMOVE LUGGAGE COMPARTMENT INNER TRIM PAD (w/o Seat Heater System)
Click here
4. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
Click here
5. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Click here
7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
Use the same procedure as for the LH side.
8. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH
Click here
9. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
10. REMOVE ROOF SIDE INNER GARNISH LH
Click here
11. REMOVE ROOF SIDE INNER GARNISH RH
HINT:
Use the same procedure as for the LH side.
12. REMOVE REAR SEAT SHOULDER BELT COVER
Click here
13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
Click here
14. REMOVE ROOM PARTITION BOARD LH
Click here
15. REMOVE FUEL PUMP CONTROL ECU
(a) Disconnect the 2 fuel pump control ECU connectors.
|
|
(b) Remove the nut and fuel pump control ECU from the vehicle body.
NOTICE:
Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.
|
|
16. REMOVE FUEL PUMP CONTROL ECU BRACKET
(a) Remove the 2 bolts and fuel pump control ECU bracket from the fuel pump control ECU.
|
|
|